Search results
Results from the WOW.Com Content Network
ifconfig is also commonly used to change the medium access control (MAC) address of an interface. In this process, the network interface is first disabled (set down) with the ifconfig command, followed by a MAC change command: ifconfig wlan0 down ifconfig wlan0 hw ether 13:11:20:33:49:66 ifconfig wlan0 up
ipconfig in Mac OS X serves as a wrapper to the IPConfiguration agent, and can be used to control the Bootstrap Protocol and DHCP client from the command-line interface. [8] For example, you can release and renew an IP address if it happened to be assigned incorrectly by the DHCP server during the automated assignment process. [9]
Red Hat Enterprise Linux 7 (Maipo) is based on Fedora 18 and Fedora 19, upstream Linux kernel 3.10, systemd 208 (updated to 219 in RHEL 7.2), and GNOME 3.8 (rebased to GNOME 3.28 in RHEL 7.6) The first beta was announced on 11 December 2013, [52] [53] and a release candidate was made available on 15 April 2014. [54]
MAC addresses need to be individually configured on the servers by an administrator. RARP is limited to serving only IP addresses . Reverse ARP differs from the Inverse Address Resolution Protocol (InARP), which is designed to obtain the IP address associated with a local Frame Relay data link connection identifier. [ 2 ]
TCP/IP defines the addresses 192.168.4.0 (network ID address) and 192.168.4.255 (broadcast IP address). The office's hosts send packets to addresses within this range directly, by resolving the destination IP address into a MAC address with the Address Resolution Protocol (ARP) sequence and then encapsulates the IP packet into a MAC frame ...
The MAC address that is hard-coded on a network interface controller (NIC) cannot be changed. However, many drivers allow the MAC address to be changed. Additionally, there are tools which can make an operating system believe that the NIC has the MAC address of a user's choosing. The process of masking a MAC address is known as MAC spoofing.
The command removes and corrects preloaded entries using a number of case-sensitive switches. The nbtstat -a < name > command performs a NetBIOS adapter status command on the computer name specified by < name >. The adapter status command returns the local NetBIOS name table for that computer as well as the MAC address of the
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router