Search results
Results from the WOW.Com Content Network
The diaphragm or bladder may itself exert a pressure on the water, but it is usually small and will be neglected in the following discussion. Case 1 is an empty tank at the charging pressure P c (gauge). The total volume of the tank is V t. Case 2 is a tank in use, with the air pressure at pressure P (gauge) and a water volume of V
Well maintained, reciprocating pumps can last for decades. Unmaintained, however, they can succumb to wear and tear. It is often used where a relatively small quantity of liquid is to be handled and where delivery pressure is quite large. In reciprocating pumps, the chamber that traps the liquid is a stationary cylinder that contains a piston ...
The basic working principle of an air-operated double diaphragm pump. Cross-section sketch of diaphragm fuel pump Air-operated double diaphragm pump. A diaphragm pump (also known as a Membrane pump) is a positive displacement pump that uses a combination of the reciprocating action of a rubber, thermoplastic or teflon diaphragm and suitable valves on either side of the diaphragm (check valve ...
It serves either as a barrier between two chambers, moving slightly up into one chamber or down into the other depending on differences in pressure, or as a device that vibrates when certain frequencies are applied to it. [1] A diaphragm pump uses a diaphragm to pump a fluid. A typical design is to have air on one side constantly vary in ...
An expansion tank or expansion vessel is a small tank used to protect closed water heating systems and domestic hot water systems from excessive pressure. The tank is partially filled with air, whose compressibility cushions shock caused by water hammer [ citation needed ] and absorbs excess water pressure caused by thermal expansion .
A rupture disc (burst) Pressure-effect acting at a rupture disc A rupture disc, also known as a pressure safety disc, burst disc, bursting disc, or burst diaphragm, is a non-reclosing pressure relief safety device that, in most uses, protects a pressure vessel, equipment or system from overpressurization or potentially damaging vacuum conditions.
A three-stage diaphragm compressor In the late 19th century William Burton started a workshop building pumps and air compressors at Nogent-sur-Oise, 60km north of Paris, France. Henri Corblin, generally recognised as the inventor of the metallic diaphragm compressor, was based nearby in Paris itself and in 1923 he received a US patent for his ...
The gas precharge in an accumulator is set so that the separating bladder, diaphragm or piston does not reach or strike either end of the operating cylinder. The design precharge normally ensures that the moving parts do not foul the ends or block fluid passages. Poor maintenance of precharge can destroy an operating accumulator.