Search results
Results from the WOW.Com Content Network
IEEE 802.3 is a working group and a collection of standards defining the physical layer and data link layer's media access control (MAC) of wired Ethernet. The standards are produced by the working group of the Institute of Electrical and Electronics Engineers (IEEE).
Only lines 1 and 2 have electrical compatibility, with T568A wiring, and only line 1 with T568B wiring, because Ethernet-compatible pin assignments split the third pair of RJ25 across two separate cable pairs, rendering that pair unusable by an analog phone. (With T568B wiring, a telephone may connect to line 3 as line 2.) Both the third and ...
A category 3 cable. Cat 3 was widely used in computer networking in the early 1990s for 10BASE-T Ethernet and, to a much lesser extent, for 100BaseVG Ethernet, Token Ring and 100BASE-T4. The original Power over Ethernet 802.3af specification supports the use of Cat 3 cable, but the later 802.3at Type 2 high-power variation does not. [8]
In Mode A, pins 1 and 2 (pair 3 in T568A wiring, pair 2 in T568B) form one side of the 48 V DC, and pins 3 and 6 (pair 2 in T568A, pair 3 in T568B) form the other side. These are the same two pairs used for data transmission in 10BASE-T and 100BASE-TX, allowing the provision of both power and data over only two pairs in such networks.
The physical network topology can be directly represented in a network diagram, as it is simply the physical graph represented by the diagrams, with network nodes as vertices and connections as undirected or direct edges (depending on the type of connection). [3] The logical network topology can be inferred from the network diagram if details ...
For example, telephone cables in the UK typically have a BS 6312 (UK standard) plug at the wall end and a 6P4C or 6P2C modular connector at the telephone end: this latter may be wired as per the RJ11 standard (with pins 3 and 4), or it may be wired with pins 2 and 5, as a straight-through cable from the BT plug (which uses pins 2 and 5 for the ...
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
Ethernet physical layer; A standard 8P8C (often called RJ45) connector used most commonly on category 5 cable, one of the types of cabling used in Ethernet networks Standard IEEE 802.3 (1983 onwards) Physical media Twisted pair, optical fiber, coaxial cable Network topology Point-to-point, star, bus Major variants