Search results
Results from the WOW.Com Content Network
Solvent degreasing is a process used to prepare a part for further operations such as electroplating or painting. Typically it uses petroleum , chlorine , dry ice or alcohol based solvents to dissolve the machining fluids and other contaminants that might be on the part.
There are two main process styles of aqueous parts washers, the jet spray process and the power wash process. In a cabinet parts washer, the parts are placed on a turntable and the door is closed. During the cleaning cycle heated solution is flooded or blasted on the parts as the turntable rotates. Many systems have a wash, rinse and dry cycle.
Chip seal products can be installed over gravel roads to eliminate the cost of grading, road roughness, dust, mud, and the cost of adding gravel lost from grading. Adding chip seal over gravel is about 25% of the price of resurfacing with asphalt, $170,000 for a 4-mile project done in Minnesota [6] compared to $760,000 had it been redone with ...
This is a list of cleaning products and agents. Cleaning agents are substances (usually liquids, powders, sprays, or granules) used to remove dirt, including dust, stains, bad smells, and clutter on surfaces. Purposes of cleaning agents include health, beauty, removing offensive odor, and avoiding the spread of dirt and contaminants to oneself ...
Cleaning agents or hard-surface cleaners are substances (usually liquids, powders, sprays, or granules) used to remove dirt, including dust, stains, foul odors, and clutter on surfaces. [1] Purposes of cleaning agents include health , beauty, removing offensive odors, and avoiding the spread of dirt and contaminants to oneself and others.
A pressure washer is used to remove old paint from a boat. Patio flagstones being pressure washed using a rotary nozzle. Pressure washing or power washing is the use of high-pressure water spray to remove loose paint, mold, grime, dust, mud, and dirt from surfaces and objects such as buildings, vehicles and concrete surfaces.
Concrete roadway in San Jose, California A concrete road in Ewing, New Jersey. Concrete surfaces (specifically, Portland cement concrete) are created using a concrete mix of Portland cement, coarse aggregate, sand, and water. In virtually all modern mixes there will also be various admixtures added to increase workability, reduce the required ...
It was first invented in 1955 by H.B. Sargent, R.M. Poorman and H. Lamprey and is applied to a component using a specifically designed detonation gun (D-gun). The component being sprayed must be prepared correctly by removing all surface oils, greases, debris and roughing up the surface in order to achieve a strongly bonded detonation spray ...