Search results
Results from the WOW.Com Content Network
In computer science, a vectored interrupt is a processing technique in which the interrupting device directs the processor to the appropriate interrupt service routine. This is in contrast to a polled interrupt system, in which a single interrupt service routine must determine the source of the interrupt by checking all potential interrupt ...
An interrupt vector table (IVT) is a data structure that associates a list of interrupt handlers with a list of interrupt requests in a table of interrupt vectors. Each entry of the interrupt vector table, called an interrupt vector, is the address of an interrupt handler (also known as ISR). While the concept is common across processor ...
The IDT consists of 256 interrupt vectors and the use of the IDT is triggered by three types of events: processor exceptions, hardware interrupts, and software interrupts, which together are referred to as interrupts: Processor exceptions generated by the CPU have fixed mapping to the first up to 32 interrupt vectors. [1]
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
a special-purpose, non-maskable interrupt (65C816 only, see below), level-triggered The detection of a RESET signal causes the processor to enter a system initialization period of six clock cycles, after which it sets the interrupt request disable flag in the status register and loads the program counter with the values stored at the processor ...
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...
The interrupt priority level (IPL) is a part of the current system interrupt state, which indicates the interrupt requests that will currently be accepted. The IPL may be indicated in hardware by the registers in a programmable interrupt controller , or in software by a bitmask or integer value and source code of threads.
In a computer, an interrupt request (or IRQ) is a hardware signal sent to the processor that temporarily stops a running program and allows a special program, an interrupt handler, to run instead. Hardware interrupts are used to handle events such as receiving data from a modem or network card , key presses, or mouse movements.