Ads
related to: 2008 mustang gt rear end gear ratio explained
Search results
Results from the WOW.Com Content Network
TREMEC engineers have recommended Texaco-Havoline Dexron III/Mercon Non-Synthetic ATF. There has been a significant amount of confusion regarding the proper capacity and proper type of ATF for the TR-3650 which may have a correlation with a rather large number of complaints about notchy shifting, shift "nibbling", noisy synchros, and grinding gears.
Complementing the transmission's gear ratio changes is a new, more aggressive 3.55:1 ratio rear axle which replaces the 3.31:1 axle used previously. According to Inside Line, drivers of the new 2010 Shelby can expect 0 to 60 mph (97 km/h) times in 4.3 seconds from a stand still and 4 seconds flat with roll out.
2005–2010 Ford Mustang V6, GT [1] 1980–1993 AOD—Ford's first 4-speed automatic transmission, based on the FMX but with a torque-splitting feature. 1992– AOD-E—Electronic AOD 1993–2008 4R70W—Strengthened AOD-E with lower 1st and 2nd gear ratios Application vary by year Ford F-Series; Ford Crown Victoria; Mercury Grand Marquis
A Tremec 5-speed manual and 3.73:1 ratio live rear axle drops 0-60 mph times to 4.9-5.0 seconds compared to the standard GT's 5.2-5.3, and quarter miles come in 13.8 seconds at 102 mph (164 km/h). Suspension is upgraded with a Bullitt-badged front tower brace and retuned suspension components that drop the ride height by 6 millimetres (0.24 in ...
WC transmissions initially carried the same maximum input torque rating of 265 lb⋅ft (359 N⋅m) until hardened first gears were introduced in approximately 1990, raising the rating to 300 lb⋅ft (410 N⋅m). Typical first gear ratios for the WC ranged from 3.35 to 3.97:1; the Ford Mustang SVO had a unique 3.50:1 first gear for 1986. [4]
Most notable of the improvements was the addition of a one-way clutch that provided smoother 1–2 up-shifts and 2–1 down-shifts. The transmission has a relatively low 1st gear and two overdrive gears, the highest of which is 0.69:1.
The Ford unit is a six-speed with one clutch acting on reverse, first, third, and fifth gears, and the other used for second, fourth, sixth gears. As the first gear is engaged, the 2-4-6 clutch is disengaged and the second gear cogs are engaged. At the appropriate time, the R-1-3-5 clutch is disengaged and the 2-4-6 clutch is engaged.
Spur-gear differential. A spur-gear differential has an equal-sized spur gears at each end, each of which is connected to an output shaft. [8] The input torque (i.e. from the engine or transmission) is applied to the differential via the rotating carrier. [8] Pinion pairs are located within the carrier and rotate freely on pins supported by the ...
Ads
related to: 2008 mustang gt rear end gear ratio explained