Search results
Results from the WOW.Com Content Network
Toyota Motor Corporation's A family is a family of automatic FWD/RWD/4WD/AWD transmissions built by Aisin-Warner.They share much in common with Volvo's AW7* and Aisin-Warner's 03-71* transmissions, which are found in Suzukis, Mitsubishis, and other Asian vehicles.
A transmission solenoid or cylinoid is an electro-hydraulic valve that controls fluid flow into and throughout an automatic transmission. Solenoids can be normally open or normally closed. They operate via a voltage or current supplied by the transmission computer or controller. Transmission solenoids are usually installed in a transmission ...
Newer automatic transmission designs often use many pressure control solenoids, and sometimes allow the shift solenoids themselves to provide precise pressure control during shifts by ramping the solenoid on and off. The shift pressure affects the shift quality (too high a pressure will result in rough shifting; too low a pressure will cause ...
The K110 was Toyota's first belt-type CVT and production began in August 2000. Toyota said that the transmission was both fuel-efficient and offered high driving performance. The K110 features a torque converter with a long-travel damper to help achieve quiet operation and improved fuel efficiency. Applications: Toyota Opa – 2.0L (2000–2005)
The J-series is a 6-speed manual transmission for rear-wheel drive applications, built by Aisin Seiki (Type AZ6). This transmission was used in the Altezza AS200 and RS200. The same Aisin AZ6 transmission is also found in other models such as the Mazda MX-5 (Miata), Nissan Silvia, Mazda RX-8, Lexus IS and Toyota 86/Scion FR-S/Subaru BRZ. Models:
Toyota’s marketing name for the transmission is "Direct Shift – 8AT 8-speed automatic transmission". [10] [11] In contrast to the UB 80E/F transmission, which was developed by Aisin AW for Toyota, the UA 80E/F was developed in a joint venture between Toyota and Aisin AW. Due to its worldwide application, development was carried out in a ...
To reduce external wiring as well as to provide a constant environment for the transmission control module (TCM), it is located inside the transmission housing. Gear shifting is managed by a computer program that oversees a clutch-to-clutch actuation that allows one clutch engage the instant the clutch from the previous gear disengages.
A variable force solenoid (VFS) is an electro-hydraulic device that controls pressure proportionally or inversely proportionally to a signal (voltage or current) obtained from the on-board controller of a powertrain. A low flow VFS is used as a signal level devices for transmission line pressure control or application of clutches.