Ad
related to: 2m 70cm swr meter digital
Search results
Results from the WOW.Com Content Network
The 70-centimeter amateur band also provides a wider spectrum than the 2-meter band (in the U.S., this is 30 MHz of spectrum, compared to only 4 MHz on the 2-meter band). [2] This allows for many more channels, accommodating fast scan television , wideband digital modes, and point-to-point linking, which may not be permitted on 2-meter and ...
As an "all-band" transceiver, the TS-2000 offers a maximum power output of 100 watts on the HF, 6 meters, and 2 meters bands, 50 watts on 70 centimeters, and, with the TS-2000X or the optional UT-20, 10 watts on the 1.2 GHz or 23 centimeters band. The (American version) radio's main receiver covers 30 kHz through 60 MHz, 142 MHz through 152 MHz ...
For 70 cm receive, PIN diode bias is provided to the PA unit, through the MAIN unit and then through an RF-decoupler network, a parallel-output shift register. A 2m signal goes to a relay and then the signals are diplexed, with 2m and < going to a lo-pass filter. The signal gets diplexed again using a hi-pass filter, separating out the 2 m ...
An amateur radio repeater system consisting of a 70 cm repeater and a 2-meter digipeater and iGate. Coaxial cavity RF filter at 2 meter repeater An amateur radio repeater is an electronic device that receives a weak or low-level amateur radio signal and retransmits it at a higher level or higher power, so that the signal can cover longer ...
An SWR meter does not measure the actual impedance of a load (the resistance and reactance), but only the mismatch ratio. To measure the actual impedance requires an antenna analyzer or other similar RF measuring device. For accurate readings, the SWR meter itself must also match the line's impedance (typically 50 or 75 Ohms).
SWR is usually measured using a dedicated instrument called an SWR meter. Since SWR is a measure of the load impedance relative to the characteristic impedance of the transmission line in use (which together determine the reflection coefficient as described below), a given SWR meter can interpret the impedance it sees in terms of SWR only if it ...
In addition, the FCC continues to require that all digital transmissions be centred on the channel-centre frequencies, which the Report and Order defines as being 1.5 kHz above the suppressed carrier frequency of a transceiver operated in the upper side-band (USB) mode. As amateur radio equipment displays the carrier frequency, it is important ...
The 2-meter amateur radio band is a portion of the VHF radio spectrum that comprises frequencies stretching from 144 MHz to 148 MHz [1] in International Telecommunication Union region (ITU) Regions 2 (North and South America plus Hawaii) and 3 (Asia and Oceania) [2] [3] and from 144 MHz to 146 MHz in ITU Region 1 (Europe, Africa, and Russia).
Ad
related to: 2m 70cm swr meter digital