Search results
Results from the WOW.Com Content Network
Other problems may be implicated in the case of older vehicles equipped with carburetors. Weak, disconnected, or mis-connected throttle return springs, worn shot-pump barrels, chafed cable housings, and cables which jump their tracks in the throttle-body crank can all cause similar acceleration problems.
However, tests of the Camry by Car and Driver in 2009, attempting to use the brakes to stop acceleration of a purposely stuck throttle at 70, 100 and 120 miles per hour (110, 160 and 190 km/h), found that the test driver was able to reduce speed to 10 mph (16 km/h) in all instances, and in the 70 and 100 mph (110 and 160 km/h) tests, stop the ...
Lift-off oversteer (also known as trailing-throttle oversteer, throttle off oversteer, or lift-throttle oversteer) is a form of sudden oversteer.While cornering, a driver who closes the throttle (by lifting a foot off the accelerator, hence the name), usually at a high speed, can cause such sudden deceleration that the vertical load on the tires shifts from rear to front, in a process called ...
The company has repeatedly denied that electronics as a source of unintended acceleration, instead attributing the problem to sticky accelerator mechanisms or to gas pedals getting hung up on ...
Congress continues to press Toyota Motor (TM) about its knowledge of problems with unintended acceleration in its vehicles. Lawmakers on Tuesday sent a letter to the world's largest automaker ...
When the car goes into the limp-home-mode it is because the accelerator, engine control computer and the throttle are not connecting to each other in which they can function together. The engine control computer shuts down the signal to the throttle position motor and a set of springs in the throttle set it to a fast idle, fast enough to get ...
In a review study published in 2012, NHTSA summarized its past findings about the Audi unintended acceleration problems: "Once an unintended acceleration had begun, in the Audi 5000, due to a failure in the idle-stabilizer system (producing an initial acceleration of 0.3g), pedal misapplication resulting from panic, confusion, or unfamiliarity ...
The problems associated with unequal-length driveshafts are endemic to the transverse engine layout combined with an end-mounted transmission unit; some manufacturers have mitigated this completely by mounting the engine longitudinally but still driving the front wheels—this indeed was the solution adopted on the earliest front-wheel-drive ...