Search results
Results from the WOW.Com Content Network
For consumer equipment it is −10 dBV, which is used to reduce manufacturing costs. [3] Expressed in absolute terms, a signal at −10 dBV is equivalent to a sine wave signal with a peak amplitude (V PK) of approximately 0.447 volts, or any general signal at 0.316 volts root mean square (V RMS).
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
This way the noise covers a bandwidth that is much wider than the signal itself. The resulting signal influence relies mainly on the filtering of the noise. To describe the signal quality without taking the receiver into account, the optical SNR (OSNR) is used. The OSNR is the ratio between the signal power and the noise power in a given bandwidth.
Audio engineers use dynamic range to describe the ratio of the amplitude of the loudest possible undistorted signal to the noise floor, say of a microphone or loudspeaker. [18] Dynamic range is therefore the signal-to-noise ratio (SNR) for the case where the signal is the loudest possible for the system. For example, if the ceiling of a device ...
Weak signal strength can also be caused by destructive interference of the signals from local towers in urban areas, or by the construction materials used in some buildings causing significant attenuation of signal strength. Large buildings such as warehouses, hospitals and factories often have no usable signal further than a few metres from ...
Sensitivity second definition: the minimum magnitude of input signal required to produce an output signal with a specified signal-to-noise ratio of an instrument or sensor. Examples of the use of this definition are given in the sections below on receivers and electronic sensors.
When a signal is chained with improper gain staging through many devices, clipping may occur or the system may operate with reduced dynamic range. In audio, a related measurement, signal-to-noise ratio , is usually defined as the difference between the nominal level and the noise floor , leaving the headroom as the difference between nominal ...
A 3 dB increase in level is approximately equivalent to doubling the power, which means that a level of 3 dBm corresponds roughly to a power of 2 mW. Similarly, for each 3 dB decrease in level, the power is reduced by about one half, making −3 dBm correspond to a power of about 0.5 mW.