Search results
Results from the WOW.Com Content Network
The axle load of a wheeled vehicle is the total weight bearing on the roadway for all wheels connected to a given axle.Axle load is an important design consideration in the engineering of roadways and railways, as both are designed to tolerate a maximum weight-per-axle (axle load); exceeding the maximum rated axle load will cause damage to the roadway or railway tracks.
For example, provide manufacturers the chassis configuration 8×4×4 to show that the vehicle has two steered front axles and two driven rear axles, compared to the chassis configuration 8×4/4 where the vehicle has one steered front axle, one steered rear axle (the fore axle) and two driven rear axles (the aft axles).
TTI HS-20 allowed shorter trucks to have higher weight limits than Formula B. For a 3-axle truck with an axle length of 14 feet (4.3 m), the weight limit increased from 46,500 pounds (21,100 kg) to 54,000 pounds (24,000 kg). [29] TTI HS-20 also failed to address the problem of multiple-span bridges. [28]
In a solid, "live-axle" suspension system, the rotating inner axle cores (or half-shafts) serve to transmit driving torque to the wheels at each end, while the rigid outer tube maintains the position of the wheels at fixed angles relative to the axle, and controls the angle of the axle and wheels assembly to the vehicle body. The solid axles ...
When evaluating the series of tests, it was found that there is a connection between the thickness of the pavement, the number of load transfers and the axle load, and that these have a direct effect on the service life and condition of a road. The service life of the road is thereby reduced with approximately the fourth power of the axle load. [1]
An axlebox, also known as a journal box in North America, is the mechanical subassembly on each end of the axles under a railway wagon, coach or locomotive; it contains bearings and thus transfers the wagon, coach or locomotive weight to the wheels and rails; the bearing design is typically oil-bathed plain bearings on older rolling stock, or roller bearings on newer rolling stock.
For premium support please call: 800-290-4726 more ways to reach us
The farther back the engine, the greater the bias. Typical weight bias for an FF (front engine, front-wheel-drive) is 65/35 front/rear; for FR, 55/45; for MR, 45/55; for RR, 35/65. A static rear weight requires less forward brake bias, as load is more evenly distributed among all four wheels under braking. Similarly, a rear weight bias means ...