enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Microvia - Wikipedia

    en.wikipedia.org/wiki/Microvia

    Ogunjimi et al. [9] looked at the effect of manufacturing and design process variables on the fatigue life of microvias, including trace (conductor) thickness, layer or layers of the dielectric around the trace and in the microvia, via geometry, via wall angle, ductility coefficient of the conductor material, and strain concentration factor ...

  3. Conformal coating - Wikipedia

    en.wikipedia.org/wiki/Conformal_coating

    Coating material (after curing) should have a thickness of 30–130 μm (0.0012–0.0051 in) when using acrylic resin, epoxy resin, or urethane resin. For silicone resin, the coating thickness recommended by the IPC standards is 50–210 μm (0.0020–0.0083 in).

  4. Printed circuit board - Wikipedia

    en.wikipedia.org/wiki/Printed_circuit_board

    Available standard laminate thickness are listed in ANSI/IPC-D-275. [ 23 ] The cloth or fiber material used, resin material, and the cloth to resin ratio determine the laminate's type designation (FR-4, CEM -1, G-10 , etc.) and therefore the characteristics of the laminate produced.

  5. Via (electronics) - Wikipedia

    en.wikipedia.org/wiki/Via_(electronics)

    PCB manufacturing typically starts with a so-called core, a basic double-sided PCB. Layers beyond the first two are stacked from this basic building block. If two more layers are consecutively stacked from bottom of core, you can have a 1-2 via, a 1-3 via and a through hole. Each type of via is made by drilling at each stacking stage.

  6. List of electronic component packaging types - Wikipedia

    en.wikipedia.org/wiki/List_of_electronic...

    The codes given in the chart below usually tell the length and width of the components in tenths of millimeters or hundredths of inches. For example, a metric 2520 component is 2.5 mm by 2.0 mm which corresponds roughly to 0.10 inches by 0.08 inches (hence, imperial size is 1008).

  7. Eurocard (printed circuit board) - Wikipedia

    en.wikipedia.org/wiki/Eurocard_(printed_circuit...

    Eurocard is an IEEE standard format for printed circuit board (PCB) cards that can be plugged together into a standard chassis which, in turn, can be mounted in a 19-inch rack. The chassis consists of a series of slotted card guides on the top and bottom, into which the cards are slid so they stand on end, like books on a shelf.

  8. Dying To Be Free - The Huffington Post

    projects.huffingtonpost.com/dying-to-be-free...

    There's A Treatment For Heroin Addiction That Actually Works. Why Aren't We Using It?

  9. Engineering drawing abbreviations and symbols - Wikipedia

    en.wikipedia.org/wiki/Engineering_drawing...

    Many corporations have such standards, which define some terms and symbols specific to them; on the national and international level, ASME standard Y14.38 [1] is one of the standards. Australia utilises the Technical Drawing standards AS1100.101 (General Principals), AS1100-201 (Mechanical Engineering Drawing) and AS1100-301 (Structural ...