enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Dorade box - Wikipedia

    en.wikipedia.org/wiki/Dorade_box

    A dorade box (also called a dorade vent, collector box, cowl vent, or simply a "ventilator") is a type of vent that permits the passage of air in and out of the cabin or engine room of a boat while keeping rain, spray, and sea wash out.

  3. Concentric tube heat exchanger - Wikipedia

    en.wikipedia.org/wiki/Concentric_tube_heat_exchanger

    Concentric Tube (or Pipe) Heat Exchangers are used in a variety of industries for purposes such as material processing, food preparation, and air-conditioning. [1] They create a temperature driving force by passing fluid streams of different temperatures parallel to each other, separated by a physical boundary in the form of a pipe.

  4. Baffle (heat transfer) - Wikipedia

    en.wikipedia.org/wiki/Baffle_(heat_transfer)

    As mentioned, baffles deal with the concern of support and fluid direction in heat exchangers. In this way it is vital that they are spaced correctly at installation. The minimum baffle spacing is the greater of 50.8 mm or one fifth of the inner shell diameter. The maximum baffle spacing is dependent on material and size of tubes.

  5. Direct vent fireplace - Wikipedia

    en.wikipedia.org/wiki/Direct_vent_fireplace

    The flue system is composed of two flues, the inner flue and the outer flue. The outer flue draws air into the bottom of the sealed firebox to allow for combustion. The inner flue draws hot exhaust gasses from the top of the sealed firebox and vents them directly to the outside of the structure through either an adjacent wall or roof.

  6. Orifice plate - Wikipedia

    en.wikipedia.org/wiki/Orifice_plate

    Orifice plate showing vena contracta. An orifice plate is a thin plate with a hole in it, which is usually placed in a pipe. When a fluid (whether liquid or gaseous) passes through the orifice, its pressure builds up slightly upstream of the orifice [1] but as the fluid is forced to converge to pass through the hole, the velocity increases and the fluid pressure decreases.

  7. Eccentric reducer - Wikipedia

    en.wikipedia.org/wiki/Eccentric_reducer

    Eccentric reducers are used at the suction side of pumps to ensure air does not accumulate in the pipe. The gradual accumulation of air in a concentric reducer could result in a large bubble that could eventually cause the pump to stall or cause cavitation when drawn into the pump. Eccentric reducers exhibit a unique design with one side having ...

  8. Ventilation (architecture) - Wikipedia

    en.wikipedia.org/wiki/Ventilation_(architecture)

    Reid advocated the installation of a very advanced ventilation system in the new House. His design had air being drawn into an underground chamber, where it would undergo either heating or cooling. It would then ascend into the chamber through thousands of small holes drilled into the floor, and would be extracted through the ceiling by a ...

  9. Beebe Hydrothermal Vent Field - Wikipedia

    en.wikipedia.org/wiki/Beebe_Hydrothermal_Vent_Field

    The vent field hosts two main areas of black smoker venting, with a fluid at temperatures of over 400 °C (752 °F) and a low salinity of about 2.3 wt% NaCl. Under these conditions, the venting fluids surpass the supercritical threshold of seawater at 407 °C (765 °F) and 298 bar, and is one of few vent sites shown to host sustained ...