Search results
Results from the WOW.Com Content Network
Pepsin is inactive at pH 6.5 and above, however pepsin is not fully denatured or irreversibly inactivated until pH 8.0. [11] [15] Therefore, pepsin in solutions of up to pH 8.0 can be reactivated upon re-acidification. The stability of pepsin at high pH has significant implications on disease attributed to laryngopharyngeal reflux. Pepsin ...
Atmospheric steam canning — Processing with 100 °C steam, not under pressure [14] Use of vintage style sealing materials such as jars with wire bails and glass caps, or zinc caps with rubber rings. Instead of a lid, cellophane and rubber bands (moldy). Using the water bath technique for low-acid foods (foods with pH greater than 4.6). [15]
The only foods that may be safely canned in an ordinary boiling water bath are highly acidic ones with a pH below 4.6, such as fruits, pickled vegetables, or other foods to which acidic additives have been added. Although an ordinary boiling temperature does not kill botulism spores, the acidity is enough to stop them from growing.
The toxicity of ammonia is dependent on both pH and temperature and an added complexity is the buffering effect of the blood/water interface across the gill membrane which masks any additional toxicity over about pH 8.0. The management of river chemistry to avoid ecological damage is particularly difficult in the case of ammonia as a wide range ...
The pH level of the mucus also plays a role in its viscosity, as higher pH levels tend to alter the thickness of the mucus, making it less viscous. [1] Because of this, invading agents such as Helicobacter pylori , a bacterium that causes stomach ulcers, can alter the pH of the mucus to make the mucus pliable enough to move through. [ 3 ]
A water bath is laboratory equipment made from a container filled with heated water. It is used to incubate samples in water at a constant temperature over a long period of time. Most water baths have a digital or an analogue interface to allow users to set a desired temperature, but some water baths have their temperature controlled by a ...
The optimum pH for its action is approximately 7. [10] Its concentration does not correlate with the amount of HCl or pepsin in the gastric juice, e.g., intrinsic factor may be present even when pepsin is largely absent. [11] The site of formation of the intrinsic factor varies in different species.
Brine (or briny water) is a high-concentration solution of salt (typically sodium chloride or calcium chloride) in water.In diverse contexts, brine may refer to the salt solutions ranging from about 3.5% (a typical concentration of seawater, on the lower end of that of solutions used for brining foods) up to about 26% (a typical saturated solution, depending on temperature).