enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Washer-dryer - Wikipedia

   en.wikipedia.org/wiki/Washer-dryer

   In the past, combo washer dryer capacity was generally smaller than that of full-size washers, and it also took much longer to process a load of laundry. Currently, available washer-dryers are able to wash 11 kilograms (24 lb) and dry 7 kilograms (15 lb) (nominal rating); they are fully comparable to standard washing machines and tumble dryers.

3. Washing machine - Wikipedia

   en.wikipedia.org/wiki/Washing_machine

   This is an accepted version of this page This is the latest accepted revision, reviewed on 30 November 2024. Machine that washes clothes For other uses, see Washing machine (disambiguation). Not to be confused with Dishwasher. LG washing machine (c. 2010) A washing machine (laundry machine, clothes washer, washer, or simply wash) is a machine designed to launder clothing. The term is mostly ...

4. Air gap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Air_gap_(plumbing)

   In the base cabinet under the sink, the drain hose from the dishwasher feeds the "top" of the air gap, and the "bottom" of the air gap is plumbed into the sink drain below the basket, or into a garbage disposal unit. When installed and maintained properly, the air gap works as described above, and prevents drain water from the sink from backing ...

5. Hydraulic head - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_head

   On Earth, additional height of fresh water adds a static pressure of about 9.8 kPa per meter (0.098 bar/m) or 0.433 psi per foot of water column height. The static head of a pump is the maximum height (pressure) it can deliver. The capability of the pump at a certain RPM can be read from its Q-H curve (flow vs. height).

6. Trap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Trap_(plumbing)

   In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.

7. Hydraulic diameter - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_diameter

   For the limiting case of a very wide duct, i.e. a slot of width b, where b ≫ a, and a is the water depth, then D H = 4a. For a fully filled duct or pipe whose cross-section is a convex regular polygon , the hydraulic diameter is equivalent to the diameter D {\displaystyle D} of a circle inscribed within the wetted perimeter .

8. Free Online Games: Play board games, card games, casino games ...

   www.aol.com/games

   Discover the best free online games at AOL.com - Play board, card, casino, puzzle and many more online games while chatting with others in real-time.

9. Comparison of pumps - Wikipedia

   en.wikipedia.org/wiki/Comparison_of_pumps

   Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...