Search results
Results from the WOW.Com Content Network
FTDI US232R : USB to RS-232 cable. A USB-to-serial adapter or simply USB adapter is a type of protocol converter that is used for converting USB data signals to and from serial communications standards (serial ports). Most commonly the USB data signals are converted to either RS-232, RS-485, RS-422, or TTL-level UART serial data.
Third-party applications can add this ability, such as the open-source com0com, freeware HW VSP3, or the commercial Virtual Serial Port Driver. Some virtual serial ports emulate all hardware serial port functionality, including all signal pin states, and permit a large number of virtual ports in any desired configuration.
The standard specifies a maximum open-circuit voltage of 25 volts: signal levels of ±5 V, ±10 V, ±12 V, and ±15 V are all commonly seen depending on the voltages available to the line driver circuit. Many RS-232 driver chips have inbuilt charge pump circuitry to produce the required voltages from a 3 or 5 volt supply. RS-232 drivers and ...
This class can be used for industrial equipment such as CNC machinery to allow upgrading from older RS-232 serial controllers and robotics, since they can keep software compatibility. The device attaches to an RS-232 communications line and the operating system on the USB side makes the USB device appear as a traditional RS-232 port.
It develops, manufactures, and supports devices and their related cables and software drivers for converting USB signals to and from various protocols, including RS-232/TTL serial (to provide support for legacy devices on modern computers lacking an accessible UART) and inter-chip communication bus protocols (e.g. SPI, I²C, JTAG, or GPIO) to ...
The written USB 3.0 specification was released by Intel and its partners in August 2008. The first USB 3.0 controller chips were sampled by NEC in May 2009, [4] and the first products using the USB 3.0 specification arrived in January 2010. [5] USB 3.0 connectors are generally backward compatible, but include new wiring and full-duplex operation.
The ELM327 abstracts the low-level protocol and presents a simple interface that can be called via a UART, typically by a hand-held diagnostic tool or a computer program connected by USB, RS-232, Bluetooth or Wi-Fi. [2] New applications include smartphones. [3] There are a large number of programs available that connect to the ELM327. [4] [5]
However, the SuperSpeed USB part of the system still implements the one-lane Gen 1×1 operation mode. Therefore, two-lane operations, namely USB 3.2 Gen 1×2 (10 Gbit/s) and Gen 2×2 (20 Gbit/s), are only possible with Full-Featured USB-C. As of 2023, they are somewhat rarely implemented; Intel, however, started to include them in its 11th ...