Search results
Results from the WOW.Com Content Network
A return period, also known as a recurrence interval or repeat interval, is an average time or an estimated average time between events such as earthquakes, floods, [1] landslides, [2] or river discharge flows to occur. It is a statistical measurement typically based on historic data over an extended period, and is used usually for risk analysis.
The period (symbol T) is the interval of time between events, so the period is the reciprocal of the frequency: T = 1/f. [ 2 ] Frequency is an important parameter used in science and engineering to specify the rate of oscillatory and vibratory phenomena, such as mechanical vibrations, audio signals ( sound ), radio waves , and light .
10 nanoseconds, also a casual term for a short period of time. microsecond: 10 −6 s: One millionth of a second. Symbol is μs millisecond: 10 −3 s: One thousandth of a second. Shortest time unit used on stopwatches. jiffy (electronics) ~ 10 −3 s: Used to measure the time between alternating power cycles. Also a casual term for a short ...
The cumulative frequency is the total of the absolute frequencies of all events at or below a certain point in an ordered list of events. [ 1 ] : 17–19 The relative frequency (or empirical probability ) of an event is the absolute frequency normalized by the total number of events:
The carrier frequency is 1800 Hz, meaning that the lower cut off frequency is 1,800 − 1,200/2 = 1,200 Hz, and the upper cutoff frequency is 1,800 + 1,200/2 = 2,400 Hz. A V.34 modem may transmit symbols at a baud rate of 3,420 Bd, and each symbol can carry up to ten bits, resulting in a gross bit rate of 3420 × 10 = 34,200 bit/s.
Failure rate is the frequency with which any system or component fails, expressed in failures per unit of time. It thus depends on the system conditions, time interval, and total number of systems under study. [1]
Frequency analysis [2] is the analysis of how often, or how frequently, an observed phenomenon occurs in a certain range. Frequency analysis applies to a record of length N of observed data X 1, X 2, X 3. . . X N on a variable phenomenon X. The record may be time-dependent (e.g. rainfall measured in one spot) or space-dependent (e.g. crop ...
The counter implementation's accuracy is limited by the clock frequency. If time is measured by whole counts, then the resolution is limited to the clock period. For example, a 10 MHz clock has a resolution of 100 ns. To get resolution finer than a clock period, there are time interpolation circuits. [6]