Search results
Results from the WOW.Com Content Network
Historically, wooden shingles were usually thin (3 ⁄ 8 to 3 ⁄ 4 in or 10 to 19 mm), relatively narrow (3 to 8 in or 76 to 203 mm), of varying length (14 to 36 in or 360 to 910 mm), and almost always planed or knifed smooth. The traditional method for making wooden shingles before the 19th century was to rive (hand split) them from straight ...
Shingles historically were called tiles, and shingle was a term applied to wood shingles, [1] as is still mostly the case outside the US. Shingles are laid in courses, usually with each shingle offset from its neighbors. The first course is the starter course and the last being a ridge course or ridge slates for a slate roof.
In the Near East, from Roman times, throughout the Middle Ages and up to the start of the 20th-century, roofs of houses were constructed in the following manner: They first arranged the wooden rafters over the walls, at a distance of about 60 cm between each rafter; over which rafters they laid down horizontally thin strips of wood, or boards ...
For premium support please call: 800-290-4726 more ways to reach us
Where the second top plate does not lap the plate immediately underneath at corner and partition intersections, these may be tied with 0.036 in (0.91 mm) galvanized steel plates at least 3 in (76 mm) wide and 6 in (150 mm) long, nailed with at least three 2 + 1 ⁄ 2 in (64 mm) nails to each wall.
Cross gabled: The result of joining two or more gabled roof sections together, forming a T or L shape for the simplest forms, or any number of more complex shapes. See also roof pitch, crow-stepped, corbie stepped, stepped gable: A gable roof with its end parapet walls below extended slightly upwards and shaped to resemble steps. A-frame
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
These buildings tend to accumulate a large amount of snow on them, which is seen as a factor in their insulation. The pitch of the roof is in part determined by the roofing material available, a pitch of 3 in 12 (1:4) or greater slope generally being covered with asphalt shingles, wood shake, corrugated steel, slate or tile.