Search results
Results from the WOW.Com Content Network
This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem or other peripheral to a computer in a typical scenario. It is present on virtually all PC serial ports - pin 1 of a nine-pin serial port, or pin eight over a 25-pin (DB25) port. Its ...
The 9-pin DE-9 connector has been used by most IBM-compatible PCs since the Serial/Parallel Adapter option for the PC-AT, where the 9-pin connector allowed a serial and parallel port to fit on the same card. [4] This connector has been standardized for RS-232 as TIA-574.
Male pinout of a 25-pin serial port (D-subminiature, DB-25) commonly found on 1980s computers. The following table lists commonly used RS-232 signals (called "circuits" in the specifications) and their pin assignments on the recommended DB-25 connectors [14] (see Serial port pinouts for other commonly used connectors not defined by the standard).
Pin No (DB25) Pin No (36 pin) Signal name Direction Register - bit Inverted 1 1 Strobe In/out Control-0 Yes 2 2 Data0 Out Data-0 No 3 3 Data1 Out Data-1 No 4 4 Data2 Out Data-2 No 5 5 Data3 Out Data-3 No 6 6 Data4 Out Data-4 No 7 7 Data5 Out Data-5 No 8 8 Data6 Out Data-6 No 9 9 Data7 Out Data-7 No 10 10 Ack In Status-6 No 11 11 Busy In Status-7
Permission is granted to copy, distribute and/or modify this document under the terms of the GNU Free Documentation License, Version 1.2 or any later version published by the Free Software Foundation; with no Invariant Sections, no Front-Cover Texts, and no Back-Cover Texts.
For example, DB-25 denotes a D-sub with a 25-position shell size and a 25-position contact configuration. The contacts in each row of these connectors are spaced 326/3000 of an inch apart, or approximately 0.1087 inches (2.76 mm), and the rows are spaced 0.112 inches (2.84 mm) apart; the pins in the two rows are offset by half the distance ...
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
Terminal verification results (TVR) or Tag '95' [1] is an EMV data object . The TVR is a series of bits set by the terminal reading an EMV card, based on logical tests (for example has the card expired).