enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Trailer connectors in North America - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   7-pin round blade connector (SAE J2863) This is common for RVs and other large trailers which have additional loads beyond the basic for tail lights and brake/turn signals. The standard is defined by SAE J2863, Automotive Trailer Tow Connector. Reversing lamps, control current to block surge brakes when reversing.

3. ISO standards for trailer connectors - Wikipedia

   en.wikipedia.org/wiki/ISO_standards_for_trailer...

   Trailer connectors between the trailer and passenger car, light truck or heavy trucks with 12V systems. In Europe, both 7-pin (ISO 1724) and 13-pin (ISO 11446) are common. The 13-pin version being phased in is newer, provides more services than the 7-pin, a more positive locking and also better protection against moisture and contamination.

4. Trailer connectors in military organizations - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in...

   Trailer connector according to NATO STANAG 4007. NATO uses a 12-pin connector [NATO 1] [NATO 2] according to STANAG 4007. [1] However, note that there are often deviations from the standard depending on which country it is applied, which means that the table below may not be accurate.

5. Trailer connectors in Europe - Wikipedia

   en.wikipedia.org/wiki/Trailer_connectors_in_Europe

   Multicon [1] Feder and Multicon WeSt (Welt Standard) connectors are precursors to ISO 11446 in a design that is intended to be compatible with ISO 1724.This means that if a towing vehicle has an outlet of this type it should be able to connect a trailer with a standard 7-pin or 5-pin connector according to ISO 1724, provided that the trailer coupling follows the standard and that the trailer ...

6. DC connector - Wikipedia

   en.wikipedia.org/wiki/DC_connector

   In the broadcast, film, and television industries, the 4-pin XLR connector is the standard for 12 V power. The connectors are wired pin 1 negative, pin 4 positive. Often pins 1 and 2 will be negative, 3 and 4 positive for a higher current rating. Female connectors are used as supply and male connectors are used on loads.

7. ISO 11446 - Wikipedia

   en.wikipedia.org/wiki/ISO_11446

   Trailer Presence Detection [c] Pin 13. Ground for pin 9 [a] ISO 11446:2004 specifies a 13-pole electrical connector between towing and towed vehicles with 12 volt electrical system. It was developed in 1987 by Erich Jaeger [1] to replace older 7-pin plugs.