Search results
Results from the WOW.Com Content Network
Ohm's law states that the electric current through a conductor between two points is directly proportional to the voltage across the two points. Introducing the constant of proportionality, the resistance, [ 1 ] one arrives at the three mathematical equations used to describe this relationship: [ 2 ] where I is the current through the conductor ...
The voltage drop (i.e., difference between voltages on one side of the resistor and the other), not the voltage itself, provides the driving force pushing current through a resistor. In hydraulics, it is similar: the pressure difference between two sides of a pipe, not the pressure itself, determines the flow through it.
v. t. e. The thermoelectric effect is the direct conversion of temperature differences to electric voltage and vice versa via a thermocouple. [1] A thermoelectric device creates a voltage when there is a different temperature on each side. Conversely, when a voltage is applied to it, heat is transferred from one side to the other, creating a ...
In electronics, voltage drop is the decrease of electric potential along the path of a current flowing in a circuit. Voltage drops in the internal resistance of the source, across conductors, across contacts, and across connectors are undesirable because some of the energy supplied is dissipated. The voltage drop across the load is proportional ...
In electrochemistry, a thermoneutral voltage is a voltage drop across an electrochemical cell which is sufficient not only to drive the cell reaction, but to also provide the heat necessary to maintain a constant temperature. For a reaction of the form. The thermoneutral voltage is given by. where is the change in enthalpy and F is the Faraday ...
However, electromotive force itself is not a physical force, [5] and ISO/IEC standards have deprecated the term in favor of source voltage or source tension instead (denoted ). [ 6 ] [ 7 ] An electronic–hydraulic analogy may view emf as the mechanical work done to water by a pump , which results in a pressure difference (analogous to voltage) .
Paschen's law is an equation that gives the breakdown voltage, that is, the voltage necessary to start a discharge or electric arc, between two electrodes in a gas as a function of pressure and gap length. [2][3] It is named after Friedrich Paschen who discovered it empirically in 1889. [4]
The Seebeck coefficient (also known as thermopower, [1] thermoelectric power, and thermoelectric sensitivity) of a material is a measure of the magnitude of an induced thermoelectric voltage in response to a temperature difference across that material, as induced by the Seebeck effect. [2] The SI unit of the Seebeck coefficient is volts per ...