Search results
Results from the WOW.Com Content Network
This standard defines property classes, the metric equivalent of a screw grade, that are almost identical to those defined by ISO 898-1, [2] except for the addition of the 8.8.3 and 10.9.3 classes. These two additional standards are fasteners that have the same mechanical properties as their base property class (i.e. 8.8 and 10.9), but are made ...
ASTM A490 and ASTM A490M are ASTM International standards for heavy hex structural bolts made from alloy steel.The imperial standard is officially titled Standard Specification for Structural Bolts, Alloy Steel, Heat Treated, 150 ksi Minimum Tensile Strength, while the metric standard (M) is titled Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural ...
In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...
Spanners for Whitworth bolts are marked with the size of the bolt, not the distance across the flats of the screw head. The most common use of a Whitworth pitch nowadays is in all UK scaffolding . Additionally, the standard photographic tripod thread, which for small cameras is 1/4" Whitworth (20 tpi) and for medium/large format cameras is 3/8 ...
The tool size needed for removal and installation depends on the type of lug nut. The three most common hex sizes for lug nuts are 17 mm, 19 mm, and 21 mm, while 22 mm, 23 mm, 11 ⁄ 16 inch (17.5 mm), and 13 ⁄ 16 inch (20.6 mm) are less commonly used.
A staple (from which the paper fastener was developed) A staple is a type of two-pronged fastener, usually metal, used for joining, gathering, or binding materials together.
Free-machining grade with reduced molybdenum and correspondingly increased phosphorus and sulfur for automatic machine screw parts as well as surgical implants and pharmaceutical processing equipment. 316N: 16–18: 10–14: 0.08: 2: 0.75: 0.045: 0.03: 0.10–0.16: 2.0–3.0: High-nitrogen grade with increased resistance to pitting and to ...
A Rockwell hardness tester. The Rockwell hardness test is a hardness test based on indentation hardness of a material. The Rockwell test measures the depth of penetration of an indenter under a large load (major load) compared to the penetration made by a preload (minor load). [1]