Search results
Results from the WOW.Com Content Network
A test setup suitable for testing receivers at microwave frequencies is shown in the figure. The two signal generators, F1 and F2, are combined using a directional coupler in reverse. That is, the two generators are connected to what would normally be the coupled and transmitted output ports respectively.
For achieving this constant speed, rotation of the disc is varied from ~8 rev/s while scanning at the inner portion of the track to ~3.5 rev/s at the outer portion. Pits and lands are the depressions (0.12 μm deep) and flat segments constituting the binary data along the track (0.6 μm width). [8]
The test continues with each sample tested at a stimulus 1 step up or down from the previous stimulus if the previous result was negative or positive. The results are tabulated and analyzed via Bruceton analysis, a simple computation of sums that can be performed by pencil and paper, to provide estimates of the mean and standard deviation.
Graph showing the temperature & humidity steps required during cyclic corrosion test D17 2028 ECC1 • An air drying phase. Depending on the test, this may be conducted at ambient temperature , or at an elevated temperature, with or without control over the relative humidity and usually by introducing a continuous supply of relatively fresh air ...
Test fixtures can be set up three different ways: in-line, delegate, and implicit. In-line setup creates the test fixture in the same method as the rest of the test. While in-line setup is the simplest test fixture to create, it leads to duplication when multiple tests require the same initial data.
In this expression, ε 1 and ε 2 are normal strains in the 1- and 2-direction and Υ 12 is the shear strain. σ 1 and σ 2 are the normal stresses and τ 12 is the shear stress. The orientation of the axes 1 and 2 in the above figure is arbitrary. This means that the values for E, G and v are the same in any material direction.
Double-pulsed chronoamperometry waveform showing integrated region for charge determination.. In electrochemistry, chronoamperometry is an analytical technique in which the electric potential of the working electrode is stepped and the resulting current from faradaic processes occurring at the electrode (caused by the potential step) is monitored as a function of time.
In electrochemistry, cyclic voltammetry (CV) is a type of voltammetric measurement where the potential of the working electrode is ramped linearly versus time. Unlike in linear sweep voltammetry , after the set potential is reached in a CV experiment, the working electrode 's potential is ramped in the opposite direction to return to the ...