Search results
Results from the WOW.Com Content Network
A test setup suitable for testing receivers at microwave frequencies is shown in the figure. The two signal generators, F1 and F2, are combined using a directional coupler in reverse. That is, the two generators are connected to what would normally be the coupled and transmitted output ports respectively.
A parity bit is a bit that is added to a group of source bits to ensure that the number of set bits (i.e., bits with value 1) in the outcome is even or odd. It is a very simple scheme that can be used to detect single or any other odd number (i.e., three, five, etc.) of errors in the output.
Test fixtures can be set up three different ways: in-line, delegate, and implicit. In-line setup creates the test fixture in the same method as the rest of the test. While in-line setup is the simplest test fixture to create, it leads to duplication when multiple tests require the same initial data.
Graph showing the temperature & humidity steps required during cyclic corrosion test D17 2028 ECC1 • An air drying phase. Depending on the test, this may be conducted at ambient temperature , or at an elevated temperature, with or without control over the relative humidity and usually by introducing a continuous supply of relatively fresh air ...
While in-circuit test is a very powerful tool for testing PCBs, it has these limitations: Parallel components can often only be tested as one component if the components are of the same type (i.e. two resistors); though different components in parallel may be testable using a sequence of different tests - e.g. a DC voltage measurement versus a measurement of AC injection current at a node.
It necessitates the test of surge immunity in electrical or electronic equipment. IEC 61000-4-5 defines test set-up, procedures, and classification levels. In particular, it standardizes the required surge voltage and current waveforms for laboratory testing, with the "1.2/50-8/20 μs" impulse being the most frequently used surge waveform.
Tensile testing, also known as tension testing, [1] is a fundamental materials science and engineering test in which a sample is subjected to a controlled tension until failure. Properties that are directly measured via a tensile test are ultimate tensile strength , breaking strength , maximum elongation and reduction in area. [ 2 ]
The Fourier transform of the cyclic autocorrelation function at cyclic frequency α is called cyclic spectrum or spectral correlation density function and is equal to: S x α ( f ) = ∫ − ∞ + ∞ R x α ( τ ) e − j 2 π f τ d τ . {\displaystyle S_{x}^{\alpha }(f)=\int _{-\infty }^{+\infty }R_{x}^{\alpha }(\tau )e^{-j2\pi f\tau ...