Search results
Results from the WOW.Com Content Network
6-volt (left) and 4.5-volt (right) lantern batteries. A lantern battery is a rectangular battery, typically an alkaline or zinc–carbon primary battery, used primarily in flashlights or lanterns. Lantern batteries are physically larger and consequently offer higher capacity than the more common flashlight batteries.
The designation for a specific motor looks like C6-3.In this example, the letter (C) represents the total impulse range of the motor, the number (6) before the dash represents the average thrust in newtons, and the number (3) after the dash represents the delay in seconds from propelling charge burnout to the firing of the ejection charge (a gas generator composition, usually black powder ...
The power improvement was negligible so Cox reverted to the cheaper easier to build Babe Bee. The engine was made for quite a few years and sold for $6.95. A left and right hand rotary valve were made, as were left hand 6×2 glass-filled nylon props for the RR-1. Some versions have a blue tank, others have a clear anodized tank.
For advanced hobby projects, sometimes the kit may only consist of a printed circuit board and assembly instructions, and the purchaser may have to source all the parts independently; or, the vendor may provide hard-to-get or pre-programmed parts while expecting the purchaser to obtain the rest of the components.
There are two types of computer-aided design systems used for the production of technical drawings: two dimensions ("2D") and three dimensions ("3D"). An example of a drawing drafted in AutoCAD. 2D CAD systems such as AutoCAD or MicroStation replace the paper drawing discipline. The lines, circles, arcs, and curves are created within the software.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A permanent magnet motor is a type of electric motor that uses permanent magnets for the field excitation and a wound armature. The permanent magnets can either be stationary or rotating; interior or exterior to the armature for a radial flux machine or layered with the armature for an axial flux topology.
These measurements are then digitized with an analog digital converter (adc) after which a microcontroller or microprocessor make the division of the current and voltage according to Ohm's law and then decode these to a display to offer the user a reading of the resistance value they're measuring at that instant.