Ad
related to: logic circuit pull up resistors free
Search results
Results from the WOW.Com Content Network
In electronic logic circuits, a pull-up resistor (PU) or pull-down resistor (PD) is a resistor used to ensure a known state for a signal. [1] It is typically used in combination with components such as switches and transistors , which physically interrupt the connection of subsequent components to ground or to V CC .
An active-low OR diode logic gate is formed by a keypad containing diodes at each switch, all connected to a shared pull-up resistor. When no switch is closed, the pull-up keeps the output high. But when the switch for any key connects to ground, the output goes low. This OR result can be used as an interrupt signal to indicate that any key has ...
See also: Diode logic § Active-high AND logic gate Open-collector buffers connected as wired AND.. The wired AND connection is a form of AND gate.When using open collector or similar outputs (which can be identified by the ⎐ symbol in schematics), wired AND only requires a pull up resistor on the shared output wire.
By tying the output of several open collectors together and connecting to a pull-up resistor, the common line becomes a wired AND in active high logic. The output will be high (true) only when all gates are in the high-impedance state, and will be low (false) otherwise, like Boolean AND.
Interconnecting any two logic families often required special techniques such as additional pull-up resistors, or purpose-built interface circuits, since the logic families may use different voltage levels to represent 1 and 0 states, and may have other interface requirements only met within the logic family.
The following is a list of 7400-series digital logic integrated circuits. ... latch, glitch-free three-state 28 SN74LS606: ... 20 kΩ pull-up open-collector 20 ...
Depletion-load NMOS logic refers to the logic family that became dominant in silicon VLSI in the latter half of the 1970s; the process supported both enhancement-mode and depletion-mode transistors, and typical logic circuits used enhancement-mode devices as pull-down switches and depletion-mode devices as loads, or pull-ups. Logic families ...
The open collector input/output is a popular alternative to three-state logic. For example, the I²C bus protocol (a bi-directional communication bus protocol often used between devices) specifies the use of pull-up resistors on the two communication lines. When devices are inactive, they "release" the communication lines and tri-state their ...
Ad
related to: logic circuit pull up resistors free