Search results
Results from the WOW.Com Content Network
The G-body designation was originally used for the 1969–1972 Pontiac Grand Prix and 1970–1972 Chevrolet Monte Carlo personal luxury cars, which rode on longer wheelbases than A-body coupes. For 1973, the Grand Prix and Monte Carlo were related to the A-body line, with all formal-roof A-body coupes designated as A-Special (and, after 1982, G ...
Coilovers are used in double wishbone suspension systems, [2] and are often a component of MacPherson struts. [3] Two of the main types of coilovers are full coilovers and slip-on coilovers. Full coilovers are matched up with a shock absorber from the factory, while with slip-on coilovers, the dampers and springs are bought separately and then ...
The General Motors G platform (also called G-body) designation was used for three different automobile platforms. 1969–1972 GM G platform (RWD) 1982–1988 GM G platform (RWD) 1995–2011 GM G platform (FWD)
The GM A platform (commonly called A-body) was a rear wheel drive automobile platform designation used by General Motors from 1925 until 1959, and again from 1964 to 1981. In 1982, GM introduced a new front wheel drive A platform , and existing intermediate rear wheel drive products were redesignated as G-bodies .
The front of the H attaches to the body via rubber bushings, and the rear of the H carries each stub-axle assembly, on each side of the car. The cross beam of the H holds the two trailing arms together, and provides the roll stiffness of the suspension, by twisting as the two trailing arms move vertically, relative to each other.
A "semi trailing-arm" (or semi trailing-link) is a common form of independent rear suspension on automobiles, particularly those with front wheel drive (where it allows a flatter rear floor pan). Leading arms are similar horizontal arms, perpendicular to the axle, but connecting the wheels to the vehicle structure via pivot joints to the rear of
4] The complete rear suspension assembly is carried in a steel crossbeam cradle (shown ghosted in the diagram below), which is attached to the vehicle body via four rubber vee-blocks and also carries the differential (blue) and inboard brakes (red). The rear wheels are located transversely by top links and wheel carriers (green) and lower links ...
Camber changes due to wheel travel, body roll and suspension system deflection or compliance. In general, a tire wears and brakes best at -1 to -2° of camber from vertical. Depending on the tire and the road surface, it may hold the road best at a slightly different angle. Small changes in camber, front and rear, can be used to tune handling.