Ads
related to: diy cb wire antenna installation video
Search results
Results from the WOW.Com Content Network
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
The antenna may not be more than 20 feet (6.1 m) above the highest point of the structure it is mounted to, or the highest point of the antenna must not be more than 60 feet (18.3 m) above the ground (47 CFR 95.408(c)) if installed in a fixed location. [4] CB radios must include AM or SSB modulation and may include frequency modulation. [5]
An inverted vee antenna is a type of antenna similar to a horizontal dipole, but with the two sides bent down towards the ground, typically creating a 120- or 90-degree angle between the dipole legs. It is typically used in areas of limited space as it can significantly reduce the ground foot print of the antenna without significantly impacting ...
A whip antenna is an antenna consisting of a straight flexible wire or rod. The bottom end of the whip is connected to the radio receiver or transmitter. A whip antenna is a form of monopole antenna. The antenna is designed to be flexible so that it does not break easily, and the name is derived from the whip-like motion that it exhibits when ...
The J-pole antenna is an end-fed omnidirectional half-wave antenna that is matched to the feedline by a shorted quarter-wave parallel transmission line stub. [5] [1] [6] For a transmitting antenna to operate efficiently, absorbing all the power provided by its feedline, the antenna must be impedance matched to the line; it must have a resistance equal to the feedline's characteristic impedance.
A ferrite loopstick antenna, a small loop used for AM reception in a portable radio, consisting of a wire wound around a ferrite core; the most common type of loop antenna today. A loop antenna is a radio antenna consisting of a loop or coil of wire, tubing, or other electrical conductor , that for transmitting is usually fed by a balanced ...
Moxon antenna for the 20-meter band.The antenna is the faint rectangle of wires held in tension by the bent X-shaped support frame. Moxon antenna for the 2-meter band. The Moxon antenna or Moxon rectangle is a simple and mechanically rugged two-element parasitic array, single-frequency antenna. [1]
The angle of the slope is usually between 45°–60° and the lower end of the wire is at least 1 ⁄ 6 wavelength above the electrical ground. [3] A sloper is typically fed with a coaxial cable in the center, at the top of the center support mast. At least 1 ⁄ 4 of the wavelength of feedline must be at 90° angle to the antenna. [3]
Ads
related to: diy cb wire antenna installation video