enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Belling-Lee connector - Wikipedia

   en.wikipedia.org/wiki/Belling-Lee_connector

   Female Belling-Lee connector on a television set. The Belling-Lee connector (also type 9,52, but largely only in the context of its specification, IEC 61169, Part 2: Radio-frequency coaxial connector of type 9,52) [1] is commonly used in Europe, parts of Southeast Asia, and Australia, to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal ...

3. Cable converter box - Wikipedia

   en.wikipedia.org/wiki/Cable_Converter_Box

   Cable-ready television sets have coaxial cable F connectors. One end connects to the cable, antenna, or VHF jack on the back of the television set; the other end connects to the wall CATV outlet. Once the television is connected through the cable to the wall CATV outlet, the television will need to be programmed to receive the cable channels.

4. Coaxial antenna - Wikipedia

   en.wikipedia.org/wiki/Coaxial_antenna

   In the most basic form, a quarter-wavelength section of coaxial cable is prepared such that the inner and outer conductors are separate but still attached to the remaining cable. The outer (shield) conductor is connected to a quarter-wavelength conducting sleeve into which the cable is inserted, and the inner conductor protrudes vertically ...

5. Television antenna - Wikipedia

   en.wikipedia.org/wiki/Television_antenna

   The standard today is 75 ohm coaxial cable, which is less susceptible to interference which plugs into an F connector or Belling-Lee connector (depending on region) on the back of the TV. [6] To convert the signal from antennas that use a twin-lead line to the modern coaxial cable input, a small transformer called a balun is used in the line.

6. DiSEqC - Wikipedia

   en.wikipedia.org/wiki/DiSEqC

   2-way DiSEqC switch 4-way DiSEqC switch with attached coaxial cables.. DiSEqC (/ ˈ d aɪ s ɛ k, d aɪ ˈ s ɛ k s i /; [citation needed] short for Digital Satellite Equipment Control) is a special communication protocol for use between a satellite receiver and a device such as a multi-dish switch or a small [1] dish antenna rotor.

7. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...