Search results
Results from the WOW.Com Content Network
Check if you can visit other sites with a different browser - If you can go to another site, the problem may be associated the browser you're using. If you don't have another browser, download a supported one for free. 2. Check the physical connection - A loose cable or cord can often be the cause of a connection problem. Make sure everything ...
Ethernet physical layer; A standard 8P8C (often called RJ45) connector used most commonly on category 5 cable, one of the types of cabling used in Ethernet networks Standard IEEE 802.3 (1983 onwards) Physical media Twisted pair, optical fiber, coaxial cable Network topology Point-to-point, star, bus Major variants
Network congestion in data networking and queueing theory is the reduced quality of service that occurs when a network node or link is carrying more data than it can handle. Typical effects include queueing delay , packet loss or the blocking of new connections.
Network congestion is a cause of packet loss that can affect all types of networks. When content arrives for a sustained period at a given router or network segment at a rate greater than it is possible to send through, there is no other option than to drop packets.
A sending station (computer or network switch) may be transmitting data faster than the other end of the link can accept it. Using flow control, the receiving station can signal the sender requesting suspension of transmissions until the receiver catches up. Flow control on Ethernet can be implemented at the data link layer.
On UTP cable, a local collision is detected on the local segment only when a station detects a signal on the RX pair at the same time it is sending on the TX pair. Since the two signals are on different pairs, there is no characteristic change in the signal. Collisions are only recognized on UTP when the station is operating in half-duplex.
The speed of light imposes a minimum propagation time on all electromagnetic signals. It is not possible to reduce the latency below = / where s is the distance and c m is the speed of light in the medium (roughly 200,000 km/s for most fiber or electrical media, depending on their velocity factor).
By reducing the original signal rate to 1 ⁄ 4 or 1 ⁄ 2, the link speed drops to 2.5 or 5 Gbit/s, respectively. [5] The spectral bandwidth of the signal is reduced accordingly, lowering the requirements on the cabling, so that 2.5GBASE-T and 5GBASE-T can be deployed at a cable length of up to 100 m on Cat 5e or better cables.