Search results
Results from the WOW.Com Content Network
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
The Diagnostic Trouble Codes (DTC's) of OBD-I vehicles can usually be found without an expensive scan tool. Each manufacturer used their own Diagnostic Link Connector (DLC), DLC location, DTC definitions, and procedure to read the DTC's from the vehicle.
DTC codes are read by a diagnostic tool, such as an OBD 2 scanner, which is plugged into the vehicle's diagnostic port. The tool communicates with the vehicle's onboard computer and retrieves the DTC codes. The codes are then interpreted by the mechanic or technician to determine the specific problem with the vehicle. [3]
Allison 1000 attached to Duramax 6.6 Diesel. The LMM (engine code "6") debuted part way through 2007 and ended production with the start of the 2011 calendar year and is mated to the 6-speed Allison transmission. The LMM was the only Duramax offered for model years 2007–2010. [6] A version was used in the Trident Iceni. [7]
1.5 L (1,493 cc or 91.1 cu in) I3, with a single overhead camshaft, four valves-per-cylinder, and common-rail direct fuel injection. This engine was designed in 1998 with the related 4-cylinder variant R 420 SOHC.
The Isuzu 6H is a family of inline six-cylinder diesel engines installed in Isuzu medium-duty trucks, and also installed in GM medium-duty trucks as the Duramax LG4. It is mated to the Allison 2500, 3000, and 3500 series transmissions.
The Duramax I4 engine is a family of turbocharged diesel I4 engines sold by General Motors in 2.5 and 2.8 liter sizes as an option for the Chevrolet Colorado, GMC Canyon, Chevrolet Express, and GMC Savana in southeast Asia and Oceania (Australia / New Zealand) from 2012, and in North America from 2016 through 2022.
Direct torque control (DTC) is one method used in variable-frequency drives to control the torque (and thus finally the speed) of three-phase AC electric motors. This involves calculating an estimate of the motor's magnetic flux and torque based on the measured voltage and current of the motor.