Search results
Results from the WOW.Com Content Network
Ptolemy's theorem states that the sum of the products of the lengths of opposite sides is equal to the product of the lengths of the diagonals. When those side-lengths are expressed in terms of the sin and cos values shown in the figure above, this yields the angle sum trigonometric identity for sine: sin(α + β) = sin α cos β + cos α sin β.
A geometric way of deriving the sine or cosine of 45° is by considering an isosceles right triangle with leg length 1. Since two of the angles in an isosceles triangle are equal, if the remaining angle is 90° for a right triangle, then the two equal angles are each 45°.
Angles measured in degrees must first be converted to radians by multiplying them by / . These approximations have a wide range of uses in branches of physics and engineering , including mechanics , electromagnetism , optics , cartography , astronomy , and computer science .
Lowest common factor may refer to the following mathematical terms: Greatest common divisor, also known as the greatest common factor; Least common multiple;
A least common multiple of a and b is a common multiple that is minimal, in the sense that for any other common multiple n of a and b, m divides n. In general, two elements in a commutative ring can have no least common multiple or more than one. However, any two least common multiples of the same pair of elements are associates. [10]
The theorem states that for a quadrilateral inscribed in a circle, the product of the lengths of the diagonals equals the sum of the products of the two pairs of lengths of opposite sides. The derivations of trigonometric identities rely on a cyclic quadrilateral in which one side is a diameter of the circle.
which by the Pythagorean theorem is equal to 1. This definition is valid for all angles, due to the definition of defining x = cos θ and y sin θ for the unit circle and thus x = c cos θ and y = c sin θ for a circle of radius c and reflecting our triangle in the y-axis and setting a = x and b = y.
The proofs given in this article use these definitions, and thus apply to non-negative angles not greater than a right angle. For greater and negative angles , see Trigonometric functions . Other definitions, and therefore other proofs are based on the Taylor series of sine and cosine , or on the differential equation f ″ + f = 0 ...