Search results
Results from the WOW.Com Content Network
J-B Weld (stylized as J-B WELD) is the name of their flagship product: a specialized, high-temperature epoxy adhesive for use in bonding materials together. The company has run advertisements showing engine block repair with J-B Weld. [2] The J-B Weld Company, founded in 1969 by Sam Bonham in Sulphur Springs, Texas, specializes in epoxy products.
The speed tip heats the rod and the substrate, while at the same time it presses the molten weld rod into position. A bead of softened plastic is laid into the joint, and the parts and weld rod fuse. With some types of plastic such as polypropylene, the melted welding rod must be "mixed" with the semi-melted base material being fabricated or ...
Like all other welding methods this process utilizes heat, time, and pressure to create a weld joint. Heat is generated from friction between the two parts when rotating and subjected to a load normal to the weld joint. This frictional heat causes the plastic to melt and a bond to be created. [1]
Weld-On is a division of IPS Corporation, a manufacturer of solvent cements, primers, and cleaners for PVC, CPVC, and ABS plastic piping systems. Weld-On products are commonly used for joining plastic pipes and fittings. Weld-On also manufactures specialty products from repair adhesives for leaking pipes, pipe thread sealants / joint compounds ...
Acrylonitrile butadiene styrene (ABS) (chemical formula (C 8 H 8) x · (C 4 H 6) y · (C 3 H 3 N) z) is a common thermoplastic polymer. Its glass transition temperature is approximately 105 °C (221 °F). [4] ABS is amorphous and therefore has no true melting point. ABS is a terpolymer made by polymerizing styrene and acrylonitrile in the ...
Solvent bonding differs from other plastic welding processes in that heating energy is generated by the chemical reaction between the solvent and thermoplastic, and cooling occurs during evaporation of the solvent. [5] Solvent bonding can be performed using a liquid or gaseous solvent.
When the welding direction is parallel to the orientation of the fibers, the weld width is usually narrower due to heat being channeled through the fibers to the front and the rear of the weld. [6] Increased volume fraction of reinforcements such as glass can scatter the laser beam, thus allowing less to be transmitted to the weld joint.
The main obstacle to overcome in this process is the setting of the parameters. For example, if over-welding occurs, then the concentration of plastic in the weld zone may be too low and cause the seal to break. If it is under-welded, the seal is incomplete. [17] Variations in the thicknesses of materials can cause variations in weld quality.