Search results
Results from the WOW.Com Content Network
Specific Northbridge IC must be used for PowerPC CPU. It is impossible to use Northbridge for Intel or AMD x86 CPU with PowerPC CPU. However it is possible to use certain types of x86 Southbridge in PowerPC based motherboards. Example: VIA 686B and AMD Geode CS5536. Apple UniNorth 2 AGP used in PowerPC 74xx Based Macs
A common example of a northbridge on a PowerPC platform is in Apple's older PowerPC-based computers like the iMac G5, which utilized an IBM CPC945 Northbridge chip. According to an Apple Developer note, The Power Mac G5's northbridge chip connected to a "Mid Bridge", which then connected to a south bridge. [9]
While the machine state register found in the PowerPC architecture and the model-specific registers found in IA-32 and x86-64 architectures fulfill similar functions and the initialism "MSR" can refer to either, there are important differences that distinguish them. The machine state register, a single register, provides coarse-grained control ...
Book III-E – Defines the supervisor instructions used for embedded applications. It is derived from the former PowerPC Book E. Book VLE – Variable Length Encoded Instruction Architecture defines alternative instructions and definitions from Books I–III, intended for higher instruction density and very-low-end applications. They use 16-bit ...
The PowerPC 970, PowerPC 970FX, and PowerPC 970MP are 64-bit PowerPC CPUs from IBM introduced in 2002. Apple branded the 970 as PowerPC G5 for its Power Mac G5 . Having created the PowerPC architecture in the early 1990s via the AIM alliance , the 970 family was created through a further collaboration between IBM and Apple .
300 MHz Motorola PowerPC 750 processor with off-die L2 cache on the CPU module from a Power Mac G3. The PowerPC 740 and 750 (codename Arthur) [2] were introduced in late 1997 as an evolutionary replacement for the PowerPC 603e. Enhancements included a faster 60x system bus (66 MHz), larger L1 caches (32 KB instruction and 32 KB data), a second ...
The ISA evolved into the PowerPC instruction set architecture and was deprecated in 1998 when IBM introduced the POWER3 processor that was mainly a 32/64-bit PowerPC processor but included the IBM POWER architecture for backwards compatibility. The original IBM POWER architecture was then abandoned. PowerPC evolved into the third Power ISA in 2006.
The existing POWER and the upcoming PowerPC ISAs were deemed unsuitable by the AS/400 team so an extension to the 64-bit PowerPC instruction set was developed called PowerPC AS for Advances Series or Amazon Series. Later, additions from the RS/6000 team and AIM Alliance PowerPC were included, and by 2001, with the introduction of POWER4, they ...