enow.com Web Search

  1. Ad

    related to: rtd sensor vs thermocouple light meter adapter model 100 diagram

Search results

  1. Results from the WOW.Com Content Network
  2. Resistance thermometer - Wikipedia

    en.wikipedia.org/wiki/Resistance_thermometer

    Resistance thermometers, also called resistance temperature detectors (RTDs), are sensors used to measure temperature. Many RTD elements consist of a length of fine wire wrapped around a heat-resistant ceramic or glass core but other constructions are also used. The RTD wire is a pure material, typically platinum (Pt), nickel (Ni), or copper ...

  3. List of temperature sensors - Wikipedia

    en.wikipedia.org/wiki/List_of_temperature_sensors

    The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...

  4. Thermopile - Wikipedia

    en.wikipedia.org/wiki/Thermopile

    Model shown is the FluxTeq PHFS-01 heat flux sensor. Voltage output is passively induced from the thermopile proportional to the heat flux through the sensor or similarly the temperature difference across the thin-film substrate and number of thermocouple junction pairs.

  5. Thermocouple - Wikipedia

    en.wikipedia.org/wiki/Thermocouple

    A thermocouple, also known as a "thermoelectrical thermometer", is an electrical device consisting of two dissimilar electrical conductors forming an electrical junction.A thermocouple produces a temperature-dependent voltage as a result of the Seebeck effect, and this voltage can be interpreted to measure temperature.

  6. Thermistor - Wikipedia

    en.wikipedia.org/wiki/Thermistor

    NTC thermistors are widely used as inrush-current limiters and temperature sensors, while PTC thermistors are used as self-resetting overcurrent protectors and self-regulating heating elements. An operational temperature range of a thermistor is dependent on the probe type and is typically between −100 and 300 °C (−148 and 572 °F).

  7. Heat detector - Wikipedia

    en.wikipedia.org/wiki/Heat_detector

    One thermocouple monitors heat transferred by convection or radiation, while the other responds to ambient temperature. The detector responds when the first sensing element's temperature increases relative to the other. Rate of rise detectors may not respond to low energy release rates of slowly developing fires.

  8. Thermopile laser sensor - Wikipedia

    en.wikipedia.org/wiki/Thermopile_laser_sensor

    Figure 2: [8] Working principle of a thermal laser sensor (Adapted from figure 3 with permission) As shown in Fig 2, a thermopile laser sensor consists of several thermocouples connected in series with one junction type (hot junction at temperature T 1) being exposed to an absorption area and the other junction type (cold junction at temperature T 2) being exposed to a heat sink.

  9. Transducer - Wikipedia

    en.wikipedia.org/wiki/Transducer

    A transducer is a device that converts energy from one form to another. Usually a transducer converts a signal in one form of energy to a signal in another. [1] Transducers are often employed at the boundaries of automation, measurement, and control systems, where electrical signals are converted to and from other physical quantities (energy, force, torque, light, motion, position, etc.).

  1. Ad

    related to: rtd sensor vs thermocouple light meter adapter model 100 diagram