Ads
related to: adjustable triangle for drafting machine parts list diagram
Search results
Results from the WOW.Com Content Network
It is used with the drafting board to draw horizontal lines and to align other drawing instruments. Wooden, metal, or plastic triangles with 30° and 60° angles or with two 45° angles are used to speed drawing of lines at these commonly used angles. A continuously adjustable 0–90° protractor is also in use.
These set squares come in two usual forms, both right triangles: one with 90-45-45 degree angles, the other with 30-60-90 degree angles. Combining the two forms by placing the hypotenuses together will also yield 15° and 75° angles. They are often purchased in packs with protractors and compasses. Less commonly found is the adjustable set square.
parts list: A list, usually tabular and often on the drawing (if not accompanying the drawing on a separate sheet), listing the parts needed in an assembly, including subparts, standard parts, and hardware. There is no consistently enforced distinction between an L/M, a BoM, or a P/L. PLM: product lifecycle management; plant lifecycle management
Set square, or triangle A set square is used in technical drawing, providing a straightedge at a right angle or another particular planar angle to a baseline. They are commonly made from clear plastic. The most common set squares are 45° squares, (one 90° corner and two 45° corners) and 60/30 triangles (a 90°, a 60° and a 30° corner).
Drafting board with a T-square and triangle. A T-square is a technical drawing instrument used by draftsmen primarily as a guide for drawing horizontal lines on a drafting table. The instrument is named after its resemblance to the letter T, with a long shaft called the "blade" and a short shaft called the "stock" or "head".
Assembly drawings show how different parts go together, identify those parts by number, and have a parts list, often referred to as a bill of materials. [16] In a technical service manual, this type of drawing may be referred to as an exploded view drawing or diagram. These parts may be used in engineering.
The list of materials (L/M, LM, LoM), bill of materials (B/M, BM, BoM), or parts list (P/L, PL) is a (usually tabular) list of the materials used to make a part, and/or the parts used to make an assembly. It may contain instructions for heat treatment, finishing, and other processes, for each part number.
[1] [2] Other names for the tool include adjustable square, combo square, and sliding square. The most common head is the standard head, which is used as a square for marking and testing 90° and 45° angles. [3] The other common types of head are the protractor head, and the centre finder head. [4]
Ads
related to: adjustable triangle for drafting machine parts list diagram