enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Working load limit - Wikipedia

   en.wikipedia.org/wiki/Working_load_limit

   An example of this would be a chain that has a MBL of 2000 lbf (8.89 kN) would have a SWL or WLL of 400 lbf (1.78 kN) if a safety factor of 5 (5:1, 5 to 1, or 1/5) is used. The current American standard for lifting and handling devices is Reference (1), which provides minimum structural and mechanical design and electrical component selection ...

3. Ultimate load - Wikipedia

   en.wikipedia.org/wiki/Ultimate_load

   In engineering, the ultimate load [1] is a statistical figure used in calculations, and should (hopefully) never actually occur.. Strength requirements are specified in terms of limit loads (the maximum loads to be expected in service) and ultimate loads (limit loads multiplied by prescribed factors of safety).

4. PC strand - Wikipedia

   en.wikipedia.org/wiki/Pc_strand

   To 15-7Φ5, for example, 5 said a single diameter 5.0mm of steel, 7Φ5 said seven of the steel wire to form a strand, and 15 that the diameter of each strand of 15mm, the total meaning is "one The beam consists of 7 strands of diameter 15 mm (each having a total diameter of about 15.24 mm, a dimensional deviation +0.40 -0.20; a diameter of ...

5. Structural load - Wikipedia

   en.wikipedia.org/wiki/Structural_load

   A structural load or structural action is a mechanical load (more generally a force) applied to structural elements. [1] [2] A load causes stress, deformation, displacement or acceleration in a structure. Structural analysis, a discipline in engineering, analyzes the effects of loads on structures and structural elements.

6. IEC 60228 - Wikipedia

   en.wikipedia.org/wiki/IEC_60228

   Comparison of SWG (red), AWG (blue) and IEC 60228 (black) wire gauge sizes from 0.03 to 200 mm² to scale on a 1 mm grid – in the SVG file, hover over a size to highlight it. In engineering applications, it is often most convenient to describe a wire in terms of its cross-section area, rather than its diameter, because the cross section is directly proportional to its strength and weight ...

7. Design load - Wikipedia

   en.wikipedia.org/wiki/Design_load

   For example, a crane with a design load of 20 tons is designed to be able to lift loads that weigh 20 tons or less. However, when a failure could be catastrophic, such as a crane dropping its load or collapsing entirely, a factor of safety is necessary. As a result, the crane should lift about 2 to 5 tons at the most.

8. These are the top 100 Black Friday deals, according to Walmart

   www.aol.com/lifestyle/these-are-the-top-100...

   Large heating pad with 4 heat settings for $16.99 (save $83) Mainstays 8-piece reversible bed in a bag comforter set for $28 Eureka Airspeed Plus Compact Upright Vacuum for $39.44 (save $29.56)

9. American wire gauge - Wikipedia

   en.wikipedia.org/wiki/American_wire_gauge

   (E.g. 1 mm diameter wire is ~18 AWG, 2 mm diameter wire is ~12 AWG, and 4 mm diameter wire is ~6 AWG). This quadruples the cross-sectional area and conductance. A decrease of ten gauge numbers (E.g. from 12 AWG to 2 AWG) multiplies the area and weight by approximately 10, and reduces the electrical resistance (and increases the conductance ) by ...