Search results
Results from the WOW.Com Content Network
The chkdsk command on Windows XP. CHKDSK can be run from DOS prompt, Windows Explorer, Windows Command Prompt, Windows PowerShell or Recovery Console. [10] On Windows NT operating systems, CHKDSK can also check the disk surface for bad sectors and mark them (in MS-DOS 6.x and Windows 9x, this is a task done by Microsoft ScanDisk).
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers (eax, ebx, etc.) and values instead of their 16-bit (ax, bx, etc.) counterparts.
CHKDSK verifies a storage volume (for example, a hard disk, disk partition or floppy disk) for file system integrity. The command has the ability to fix errors on a volume and recover information from defective disk sectors of a volume. The command is available in MS-DOS versions 1 and later. [1]
The recovery console is used to provide a way to access the hard drive in an emergency through the command prompt. The Recovery Console can be started from Windows 2000 / XP / 2003 Setup CD. The Recovery Console can be accessed in two ways, either through the original installation media used to install Windows, or by installing it onto the hard ...
COMMAND.COM is the default command-line interpreter for MS-DOS, Windows 95, Windows 98 and Windows Me.In the case of DOS, it is the default user interface as well. [2] It has an additional role as the usual first program run after boot (init process), hence being responsible for setting up the system by running the AUTOEXEC.BAT configuration file, and being the ancestor of all processes.
It included a more user-friendly interface than CHKDSK, more configuration options, [2] [3] and the ability to detect and (if possible) recover from physical errors on the disk. This replaced and improved upon the limited ability offered by the MS-DOS recover utility. [4] Unlike CHKDSK, ScanDisk would also repair crosslinked files. [5]
Commodore DOS, also known as CBM DOS, is the disk operating system used with Commodore's 8-bit computers.Unlike most other DOSes, which are loaded from disk into the computer's own RAM and executed there, CBM DOS is executed internally in the drive: the DOS resides in ROM chips inside the drive, and is run there by one or more dedicated MOS 6502 family CPUs.
A block, a contiguous number of bytes, is the minimum unit of storage that is read from and written to a disk by a disk driver.The earliest disk drives had fixed block sizes (e.g. the IBM 350 disk storage unit (of the late 1950s) block size was 100 six-bit characters) but starting with the 1301 [8] IBM marketed subsystems that featured variable block sizes: a particular track could have blocks ...