Search results
Results from the WOW.Com Content Network
The NS-10 is an 8-ohm two-way loudspeaker with a 10.4-litre sealed cabinet measuring 382 × 215 × 199 millimetres (15.0 × 8.5 × 7.8 in) and weighing 6 kilograms (13.2 lb). [5] [4] Its 2.5 cm (0.98 in) particle-board cabinet has a wood veneer skin with seven black finishing layers. The domestic version of the speaker was vertically oriented ...
First introduced in 1948, it sported the name "Champion 800" [2] (with 8" speaker), changing a year later to "Champion 600" (6" speaker) with circuit designation 5B1. It was rated at about 3 watts, featuring a "T.V. Front" style cabinet; the 800 was covered in greenish fabric while the 600 featured two-tone blonde and brown vinyl covering.
American EIA standard RS-299A specifies that (or DCR) should be at least 80% of the rated driver impedance, so an 8-ohm rated driver should have a DC resistance of at least 6.4 ohms, and a 4-ohm unit should measure 3.2 ohms minimum. This standard is voluntary, and many 8-ohm drivers have resistances of ≈5.5 ohms, and proportionally lower for ...
Another popular format is four 10" or four 12" speakers. Some performers use two 4x10" or 4x12" cabinets. The largest guitar speaker cabinets have eight 10" or 12" speakers. A 4x12" ("four by twelve") is a guitar speaker cabinet containing four 12" speakers. Less commonly, some bass amp cabinets have multiple 8" speakers (e.g., the 8x8" cabinet).
Sixteen ohm drivers (or loudspeakers systems) would be connected to the 16-ohm tap, 8 ohm to the 8 ohm tap, etc. This is significant since the ratio between the loudspeaker impedance and the amplifier's impedance at a particular frequency provides damping (i.e., energy absorption) for the back EMF generated by a driver.
The E-202 has a Speaker Damping Control which permits choice of three damping factors and induces maximum potential performance from any speaker. Damping factor with an 8 Ω load becomes more than 50 when this control is set to NORMAL. Likewise, it is 5 at MEDIUM position, and 1 at SOFT position. It enables choosing the speaker sound that one ...
[citation needed] High-power in-car audio systems using 2-ohm speaker circuits require thicker wire than 4 to 8-ohm home audio applications. Most consumer applications use two conductor wire. A common rule of thumb is that the resistance of the speaker wire should not exceed 5 percent of the rated impedance of the system.
The Pioneer SX-1980 [1] [2] [3] is an AM/FM radio receiver that Pioneer Corporation introduced in 1978, to be matched with the HPM series of speakers. It was rated at 270 watts RMS per channel into 8 ohms , both channels driven.