enow.com Web Search

  1. Ads

    related to: micro usb input 5 pins 2

Search results

  1. Results from the WOW.Com Content Network
  2. USB hardware - Wikipedia

    en.wikipedia.org/wiki/USB_hardware

    The USB 3.0 Micro-B plug effectively consists of a standard USB 2.0 Micro-B cable plug, with an additional 5 pins plug "stacked" to the side of it. In this way, cables with smaller 5 pin USB 2.0 Micro-B plugs can be plugged into devices with 10 contact USB 3.0 Micro-B receptacles and achieve backward compatibility.

  3. USB - Wikipedia

    en.wikipedia.org/wiki/USB

    The USB 3.0 specification defined a new architecture and protocol named SuperSpeed (aka SuperSpeed USB, marketed as SS), which included a new lane for a new signal coding scheme (8b/10b symbols, 5 Gbit/s; later also known as Gen 1) providing full-duplex data transfers that physically required five additional wires and pins, while preserving the ...

  4. Mobile High-Definition Link - Wikipedia

    en.wikipedia.org/wiki/Mobile_High-Definition_Link

    This permits a much lighter cable and a much smaller connector on the mobile device, as a typical MHL source will be shared with USB 2.0 on a standard 5-pin Micro-USB receptacle. [1] (Although MHL ports can be dedicated to MHL alone, the standard is designed to permit port sharing with the most commonly used ports.)

  5. USB On-The-Go - Wikipedia

    en.wikipedia.org/wiki/USB_On-The-Go

    [5] [6] An OTG cable has a micro-A plug on one end, and a micro-B plug on the other end (it cannot have two plugs of the same type). OTG adds a fifth pin to the standard USB connector, called the ID-pin; the micro-A plug has the ID pin grounded, while the ID in the micro-B plug is floating.

  6. List of Arduino boards and compatible systems - Wikipedia

    en.wikipedia.org/wiki/List_of_Arduino_boards_and...

    Micro-B USB jack for power and/or USB uploading. 5 GPIO - 2 shared with the USB interface. The 3 independent I/O pins have 1 analog input (ADC) and 2 PWM output as well. Hardware I²C / SPI capability for breakout & sensor interfacing. Works with many basic Arduino libraries including RainbowBit library. Digispark [170] ATtiny85 Digistump [171]

  7. USB 3.0 - Wikipedia

    en.wikipedia.org/wiki/USB_3.0

    The USB 3.0 specification defined a new architecture and protocol, named SuperSpeed, which included a new lane for providing full-duplex data transfers that physically required five additional wires and pins, while also adding a new signal coding scheme (8b/10b symbols, 5 Gbit/s; also known later as Gen 1), and preserving the USB 2.0 ...

  1. Ads

    related to: micro usb input 5 pins 2