enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Molding (decorative) - Wikipedia

   en.wikipedia.org/wiki/Molding_(decorative)

   A "speed base" makes use of a base "cap moulding" set on top of a plain 1" thick board, however there are hundreds of baseboard profiles. Baton: See Torus; Batten or board and batten: Symmetrical moulding that is placed across a joint where two parallel panels or boards meet; Bead moulding: Narrow, half-round convex moulding, when repeated ...

3. Quarter round - Wikipedia

   en.wikipedia.org/wiki/Quarter_round

   Quarter round molding at the edge of a parquet floor. A quarter round is a convex molding whose cross section is a quarter circle. It is one form of ovolo. A variation is a base shoe, a quarter of an ellipse. [1] Most quarter round is of small gauge and relatively flexible.

4. Design of plastic components - Wikipedia

   en.wikipedia.org/wiki/Design_of_plastic_components

   The design of injection moulded components can be further improved and optimised by using injection moulding simulation software such as Autodesk Moldflow [5] and SolidWorks Plastics. [6] This software works with components designed in CAD to simulate how a polymer behaves when it enters a injection mould cavity.

5. These Crown Molding Design Ideas Are Edgy AF

   www.aol.com/crown-molding-design-ideas-edgy...

   These Crown Molding Design Ideas Are Edgy AF. Sean Santiago. February 14, 2024 at 2:08 PM. ... By using molding as trim slightly lower than the crown molding, a sense of grandeur is added to this ...

6. Egg-and-dart - Wikipedia

   en.wikipedia.org/wiki/Egg-and-dart

   Egg-and-dart molding at the top of an Ionic capital at the Jefferson Memorial. Egg-and-dart, also known as egg-and-tongue, egg-and-anchor, or egg-and-star, [1] is an ornamental device adorning the fundamental quarter-round, convex ovolo profile of moulding, consisting of alternating details on the face of the ovolo—typically an egg-shaped object alternating with a V-shaped element [1] (e.g ...

7. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   Bits also differ by the diameter of their shank, with 1 ⁄ 2-inch, 12 mm, 10 mm, 3 ⁄ 8-inch, 8 mm and 1 ⁄ 4-inch and 6 mm shanks (ordered from thickest to thinnest) being the most common. Half-inch bits cost more but, being stiffer, are less prone to vibration (giving smoother cuts) and are less likely to break than the smaller sizes.