Search results
Results from the WOW.Com Content Network
Rebar (short for reinforcement bar or reinforcing bar), known when massed as reinforcing steel or steel reinforcement, [1] is a tension device added to concrete to form reinforced concrete and reinforced masonry structures to strengthen and aid the concrete under tension.
The EN 10080: Steel for the reinforcement of concrete is a European Standard. This standard is referenced by EN 1992 . This standard specifies general requirements and definitions for performance characteristics of steel reinforcement suitable for welding, which is used for reinforcement of concrete structures, supplied as finished products:
The reinforcing steel in the bottom part of the beam, which will be subjected to tensile forces when in service, is placed in tension before the concrete is poured around it. Once the concrete has hardened, the tension on the reinforcing steel is released, placing a built-in compressive force on the concrete.
Stainless steel is an iron-carbon alloy with a minimum of 10.5% chromium content. There are different types of stainless steel, containing different proportions of iron, carbon, molybdenum, nickel. It has similar structural properties to steel, although its strength varies significantly.
The applied reinforcement yield stress is = 500 N/mm². The mass density of the reinforcing bars is 7800 kg/m 3. In the table is the computed brittle material stress. is the optimised amount of reinforcement.
The use of reinforcement, in the form of iron was introduced in the 1850s by French industrialist François Coignet, and it was not until the 1880s that German civil engineer G. A. Wayss used steel as reinforcement. Concrete is a relatively brittle material that is strong under compression but less in tension.
Image source: The Motley Fool. Commercial Metals (NYSE: CMC) Q1 2025 Earnings Call Jan 06, 2025, 11:00 a.m. ET. Contents: Prepared Remarks. Questions and Answers. Call Participants
To hoist the steel, structural ironworkers use cables connected to the crane to lift the beams onto the steel columns. A rope called a tagline is attached to the beams so an ironworker can control them when needed. The crane hoists steel into place, and the ironworkers position the beams with spud wrenches to align bolt holes.