enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Solder paste - Wikipedia

   en.wikipedia.org/wiki/Solder_paste

   Solder paste is used in the manufacture of printed circuit boards to connect surface mount components to pads on the board. It is also possible to solder through-hole pin in paste components by printing solder paste in and over the holes. The sticky paste temporarily holds components in place; the board is then heated, melting the paste and ...

3. Soldering station - Wikipedia

   en.wikipedia.org/wiki/Soldering_station

   A soldering station is a multipurpose power soldering device designed for electronic components soldering. This type of equipment is mostly used in electronics and electrical engineering . Soldering station consists of one or more soldering tools connected to the main unit, which includes the controls (temperature adjustment), means of ...

4. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

5. Flat no-leads package - Wikipedia

   en.wikipedia.org/wiki/Flat_no-leads_package

   Different manufacturers use different names for this package: ML (micro-leadframe) versus FN (flat no-lead), in addition there are versions with pads on all four sides (quad) and pads on just two sides (dual), thickness varying between 0.9–1.0 mm for normal packages and 0.4 mm for extremely thin. Abbreviations include:

6. Reflow soldering - Wikipedia

   en.wikipedia.org/wiki/Reflow_soldering

   Reflow soldering is a process in which a solder paste (a sticky mixture of powdered solder and flux) is used to temporarily attach anywhere from one to thousands of tiny electrical components to their contact pads, after which the entire assembly is subjected to controlled heat. The solder paste reflows in a molten state, creating permanent ...

7. Dual in-line package - Wikipedia

   en.wikipedia.org/wiki/Dual_in-line_package

   When the identifying notch in the package is at the top, Pin 1 is the top left corner of the device. Sometimes Pin 1 is identified with an indent or paint dot mark. For example, for a 14-lead DIP, with the notch at the top, the left leads are numbered from 1 to 7 (top to bottom) and the right row of leads are numbered 8 to 14 (bottom to top).