Search results
Results from the WOW.Com Content Network
The GM High Feature engine (also known as the HFV6, and including the 3600 LY7 and derivative LP1) is a family of modern DOHC V6 engines produced by General Motors. The series was introduced in 2004 with the Cadillac CTS and the Holden Commodore (VZ). It is a 60° 24-valve design with aluminum block and heads and sequential multi-port fuel ...
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
Atlas is a name for a family of modern inline piston engines for trucks from General Motors, used in the GMT355 and GMT360 platforms. The series debuted in 2002 with the Oldsmobile Bravada, and is also used in the Buick Rainier, the Chevrolet TrailBlazer and Colorado, the GMC Envoy and Canyon, the Hummer H3, Isuzu Ascender and i-370, and the Saab 9-7X.
The GMC straight-6 engine was a series of gasoline-powered straight-six engines introduced in the 1939 model year by the GMC Trucks division of General Motors. Prior to the introduction of this new engine design GMC trucks had been powered by straight-six engines designed by the Buick , Pontiac and Oldsmobile divisions of GM.
This engine displaced 186.7 cu in (3.1 L) with a bore and stroke of 3.25 in × 3.75 in (82.6 mm × 95.3 mm) and was rated at 40 hp (30 kW; 41 PS) at 2400 rpm when it was introduced. The compression ratio was 4.8:1.
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in³ (1980-1983).
The Northstar engine is a family of high-performance 90° V engines produced by General Motors between 1993 and 2011. Regarded as GM's most technically complex engine, the original double overhead cam, four valve per cylinder, aluminum block/aluminum head V8 design was developed by Oldsmobile R&D, [citation needed] but is most associated with Cadillac's Northstar series.
The engines were also sold for marine and stationary applications. In a 1938 reorganization, Winton Engine Corporation became the GM Cleveland Diesel Engine Division, and GM's Detroit Diesel Engine Division began production of smaller (50–149 cu in (0.8–2.4 L) per cylinder) diesel engines. Locomotive engines were moved under the GM Electro ...