enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Paper size - Wikipedia

   en.wikipedia.org/wiki/Paper_size

   Comparison of ISO 216 and Swedish standard SIS 014711 paper sizes between A4 and A3 sizes. The Swedish standard SIS 01 47 11 [9] generalized the ISO system of A, B, and C formats by adding D, E, F, and G formats to it. Its D format sits between a B format and the next larger A format (just like C sits between A and the next larger B).

3. ISO 216 - Wikipedia

   en.wikipedia.org/wiki/ISO_216

   Successive paper sizes in the series (A1, A2, A3, etc.) are defined by halving the area of the preceding paper size and rounding down, so that the long side of A(n + 1) is the same length as the short side of An. Hence, each next size is nearly exactly half the area of the prior size. So, an A1 page can fit two A2 pages inside the same area.

4. Traditional point-size names - Wikipedia

   en.wikipedia.org/wiki/Traditional_point-size_names

   The sizes were gradually standardized as described above. [3] Modern Chinese typography uses the following names in general preference to stating the number of points. In ambiguous contexts, the word hào (t 號, s 号, lit. "number") is added to the end of the size name to clarify the meaning.

5. Newspaper format - Wikipedia

   en.wikipedia.org/wiki/Newspaper_format

   Comparison of some newspaper sizes with metric paper sizes. Approximate nominal dimensions are in millimetres. ... A3 420 mm × 297 mm (16.5 in × 11.7 in) A4 297 mm ...

6. Foolscap folio - Wikipedia

   en.wikipedia.org/wiki/Foolscap_folio

   A comparison of the A4 and Foolscap folio papersize. Foolscap folio, commonly contracted to foolscap or cap or folio and in short FC, is paper cut to the size of 8.5 × 13.5 in (216 × 343 mm) for printing or to 8 × 13 in (203 × 330 mm) for "normal" writing paper (foolscap). [1]

7. Point (typography) - Wikipedia

   en.wikipedia.org/wiki/Point_(typography)

   Microsoft Word, for instance, suggests every even size between 8 and 28 points and, additionally, 9, 11, 36, 48 and 72 points, i.e. the larger sizes equal 3, 4 and 6 picas. While most software nowadays defaults to DTP points, many allow specifying font size in other units of measure (e.g., inches, millimeters, pixels), especially code-based ...