Search results
Results from the WOW.Com Content Network
The moment of inertia (technically, second moment of area) of the hull section is calculated by finding the neutral or central axis of the beam and then totaling up the quantity = + for each section of plate or girder making up the hull, with being the moment of inertia of that section of material, being the width (horizontal dimension) of the ...
Bulkheads were known to the ancient Greeks, who employed bulkheads in triremes to support the back of rams. By the Athenian trireme era (500 BC), [1] the hull was strengthened by enclosing the bow behind the ram, forming a bulkhead compartment. Instead of using bulkheads to protect ships against rams, Greeks preferred to reinforce the hull with ...
A subdivision of the sheet plywood boat building method is known as the stitch-and-glue method, [8] where pre-shaped panels of plywood are drawn together then edge glued and reinforced with fibreglass without the use of a frame. [9] Metal or plastic ties, nylon fishing line or copper wires pull curved flat panels into three-dimensional curved ...
A hull is the watertight body of a ship, boat, submarine, or flying boat. The hull may open at the top (such as a dinghy), or it may be fully or partially covered with a deck. Atop the deck may be a deckhouse and other superstructures, such as a funnel, derrick, or mast. The line where the hull meets the water surface is called the waterline.
An autoCAD drawing of the various plating strakes on a convention hull. A strake is the name given to each line of planking in a wooden vessel. [1] In modern ship construction it refers to the longitudinal run of plating covering the hull, deck and bulkhead structure. Certain specific strakes are uniquely identified:
Frames support the hull and give the ship its shape and strength. In wooden shipbuilding, each frame is composed of several sections, so that the grain of the wood can follow the curve of the frame. Starting from the keel, these are the floor (which crosses the keel and joins the frame to the keel), the first futtock , the second futtock , the ...
A strongback is a beam or girder which acts as a secondary support member to an existing structure. A strongback in a staircase is usually ordinary two-by dimensional lumber attached to the staircase stringers to stiffen the assembly.
A girt is a vertically aligned girder placed to resist shear loads. Small steel girders are rolled into shape. Larger girders (1 m/3 feet deep or more) are made as plate girders, welded or bolted together from separate pieces of steel plate. [2] The Warren type girder replaces the solid web with an open latticework truss between the flanges ...