Search results
Results from the WOW.Com Content Network
Eccentric reducers exhibit a unique design with one side having a larger diameter and the other side being smaller and offset from the centerline. This offset configuration enables the eccentric reducer to maintain a consistent fluid level within the piping system, preventing air or gas accumulation.
A coupling whose ends use the same connection method but are of different sizes is called a reducing coupling or reducer. An example is a 3/4" NPT to 1/2" NPT coupling. An example is a 3/4" NPT to 1/2" NPT coupling.
Although flange fittings are bulky, they perform well in demanding applications such as large water supply networks and hydroelectric systems. Flanges are rated at 150, 300, 400, 600, 900, 1500, and 2500 psi; or 10, 15, 25, 40, 64, 100, and 150 bars of pressure. Various types of flanges are available, depending on construction.
A concentric reducer is used to join pipe sections or tube sections on the same axis. [1] The concentric reducer is cone -shaped, and is used when there is a shift in diameter between pipes. [ 1 ] For example, when a 1" pipe transitions into a 3/4" pipe and the top or bottom of the pipe doesn't need to remain level. [ 2 ]
A cycloidal drive or cycloidal speed reducer is a mechanism for reducing the speed of an input shaft by a certain ratio. Cycloidal speed reducers are capable of relatively high ratios in compact sizes with very low backlash. [1] The input shaft drives an eccentric bearing that in turn drives the cycloidal disc in an eccentric, cycloidal motion ...
In plumbing and piping, a nipple is a fitting, consisting of a short piece of pipe, usually provided with a male pipe thread at each end, for connecting two other fittings. The length of the nipple is usually specified by the overall length with thread.
In a year in which it seemed every great luminary got a moment under the documentary lens, it can be a bit difficult to parse out which were must-see. This list will have you covered.
Gate valves may have flanged ends drilled according to pipeline-compatible flange dimensional standards. Gate valves are typically constructed from cast iron, cast carbon steel, ductile iron, gunmetal, stainless steel, alloy steels, and forged steels. All-metal gate valves are used in ultra-high vacuum chambers to isolate regions of the chamber ...