enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   Such a drill bit is called a reduced-shank or blacksmith's drill. For example, this allows a 1 ⁄ 2 -inch (13 mm) bit to be used in a pistol-grip drill's 3 ⁄ 8 -inch (9.5 mm) chuck. One particular type of reduced-shank drill bits are Silver & Deming ( S&D ) bits, whose sets run from 9 ⁄ 16 -inch (14 mm) to 1 + 1 ⁄ 2 -inch (38 mm) drill ...

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   set bolt: tap bolt, setscrew: A bolt that is threaded all the way to the head. An ASME B18.2.1 compliant set/tap bolt has the same tolerances as an ASME B18.2.1 compliant hex cap screw. set screw: grub screw: A set screw is generally a headless screw but can be any screw used to fix a rotating part to a shaft, such as a line shaft or ...

4. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   A spade drill bit for metal is a two part bit with a tool holder and an insertable tip, called an insert. The inserts come in various sizes that range from 7 ⁄ 16 to 2.5 inches (11 to 64 mm). The tool holder usually has a coolant passage running through it. [13] They are capable of cutting to a depth of about 10 times the bit diameter.

5. Confirmat screw - Wikipedia

   en.wikipedia.org/wiki/Confirmat_screw

   Confirmats may be made of steel, galvanised steel, and nickel and aluminium-zinc alloys. [5] They commonly come in lengths of 40, 50 and 70 millimetres (1.6, 2.0 and 2.8 in), and in shank sizes of 5, 6.3 and 7 millimetres (0.20, 0.25 and 0.28 in), with Phillips drive or hex heads .

6. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   The hex head is used to drive the bolt into the countersunk hole, then either a wrench or hammer is used to break the shank and hex head from the flat head, or it is driven until the driving head shears off. Either method leaves only a smooth bolt head exposed. This type of bolt is commonly used with prison door locks, automobile ignition ...

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.