Search results
Results from the WOW.Com Content Network
The Q factor is a parameter that describes the resonance behavior of an underdamped harmonic oscillator (resonator). Sinusoidally driven resonators having higher Q factors resonate with greater amplitudes (at the resonant frequency) but have a smaller range of frequencies around that frequency for which they resonate; the range of frequencies for which the oscillator resonates is called the ...
The quality factor (or Q) of an inductor is the ratio of its inductive reactance to its resistance at a given frequency, and is a measure of its efficiency. The higher the Q factor of the inductor, the closer it approaches the behavior of an ideal inductor.
Q-meter E9-4. Internally, a minimal Q meter consists of a tuneable RF generator with a very low (pass) impedance output and a detector with a very high impedance input. There is usually provision to add a calibrated amount of high Q capacitance across the component under test to allow inductors to be measured in isolation.
The quality of the resonance (how long it will ring when excited) is determined by its Q factor, which is a function of resistance: =. An idealized, lossless LC circuit has infinite Q , but all actual circuits have some resistance and finite Q , and are usually approximated more realistically by an RLC circuit .
High and low Q factor. The Q factor or quality factor is a dimensionless parameter that describes how under-damped an oscillator or resonator is, and characterizes the bandwidth of a resonator relative to its center frequency. [23] [24] A high value for Q indicates a lower rate of energy loss relative to the stored energy, i.e., the system is ...
Series RL, parallel C circuit with resistance in series with the inductor is the standard model for a self-resonant inductor. A series resistor with the inductor in a parallel LC circuit as shown in Figure 4 is a topology commonly encountered where there is a need to take into account the resistance of the coil winding and its self-capacitance.
Hay's bridge is used to determine the Inductance of an inductor with a high Q factor. Maxwell's bridge is only appropriate for measuring the values for inductors with a medium quality factor. [ 1 ] Thus, the bridge is the advanced form of Maxwell’s bridge.
Readings should be reasonably accurate if the capacitor or inductor device under test does not have a significant resistive component of impedance. More advanced designs measure true inductance or capacitance, as well as the equivalent series resistance of capacitors and the Q factor of inductive components.