enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Plumbing fixture - Wikipedia

   en.wikipedia.org/wiki/Plumbing_fixture

   Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.

3. Backflow prevention device - Wikipedia

   en.wikipedia.org/wiki/Backflow_prevention_device

   A backflow prevention device is used to protect potable water supplies from contamination or pollution due to backflow. In water distribution systems, water is normally maintained at a significant pressure to enable water to flow from the tap, shower, or other fixture. Water pressure may fail or be reduced when a water main bursts, pipes freeze ...

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Copper fittings for soldered joints. Pipe fittings: 1) Copper (solder); 2) Iron or brass (threaded); 3) Brass (compression); 4) Brass (compression to solder); 5) Brass adapters. PVC fittings. A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube ...

5. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   Plumbing. A complex arrangement of rigid steel piping and stop valves regulate flow to various parts of the building, with an evident preference for right-angle pipe bends and orthogonal pipe routes. Plumbing is any system that conveys fluids for a wide range of applications.

6. Tap (valve) - Wikipedia

   en.wikipedia.org/wiki/Tap_(valve)

   A fibre washer (which expands when wet, aiding the seal) is used between the connector and the tap tail. Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size. The same connection method is used for a ballcock.

7. Plumber - Wikipedia

   en.wikipedia.org/wiki/Plumber

   Plumbing work is defined in the Australian Standards (AS3500) Regulations 2013 and refers to any operation, work or process in connection with installation, removal, demolition, replacement, alteration, maintenance or repair to the system of pipes and fixtures that conveys clean water into and liquid waste out of a building.